Abstract:A simple, room-temperature bonding process was developed for the fabrication of glass microfluidic chips. High-quality bonding with high yields (>95%) was achieved without the requirement of clean room facilities, programmed high-temperature furnaces, pressurized water sources, adhesives, or pressurizing weights. The plates to be bonded were sequentially prewashed with acetone, detergent, high-flow-rate (10-20 m/s) tap water, and absolute ethyl alcohol and were soaked in concentrated sulfuric acid for 8-12 h. The plates were again washed in high-flow-rate tap water for 5 min and, finally, with demineralized water. The plates were bonded by bringing the cleaned surfaces into close contact under a continuous flow of demineralized water and air-dried at room temperature for more than 3 h. This bonding process features simple operation, good smoothness of the plate surface, and high bonding yield. The procedures can be readily applied in any routine laboratory. The bonding strength of glass chips thus produced, measured using a shear force testing procedure, was higher than 6 kg/cm(2). The mechanism for the strong bonding strength is presumably related to the formation of a hydrolyzed layer on the plate surfaces after soaking the substrates in acid or water for extended periods. Microfluidic chips bonded by the above procedure were tested in the CE separation of fluorescein isothiocyanate-labeled amino acids.

Micro Fabrication of Micro Fluidic Glass Chip Without Clean Room Condition

Bonding of Glass-Based Microfluidic Chips at Low- or Room-Temperature in Routine Laboratory

Fabrication of full glass chips with hybrid micro- and nanochannels and their application to protein concentration

Bonding of Glass Microfluidic Chips at Room Temperatures

Method For Fabrication Of Microfluidic Glass Chips

A Simplified Microfabrication Technology For Production Of Glass Microfluidic Chips

Study on the Manufacture of Microfluidic Chip with Coated Glass

Fabrication of Micro/Nanofluidic Chip on Glass Substrate and Its Application for Electrokinetic Concentration of Proteins

Study on a Practical Fabrication of Glass Microfluidic Chip

Study on a Low-Cost and Fast Fabrication Method of Glass Microfluidic Chips

Microcontact Electrochemical Etching Technique for Rapid Fabrication of Glass-Based Microfluidic Chips

Microfabrication of Capillary Electrophoresis chips

Fabrication Of Microfluidic Chips By An Ultrasonic Micromachining With Wet-Etch Smoothing Method On Glass Substrates

Fabricating Microstructures on Glass for Microfluidic Chips by Glass Molding Process

Micro Etching Method Inside Microchannels

Low-cost Fabrication Technology of Glass-based Microfluidic Chip

A simple approach to fabricate multi-layer glass microfluidic chips based on laser processing and thermocompression bonding

Fabrication of Glass-Based Microfluidic Devices with Dry Film Photoresists As Pattern Transfer Masks for Wet Etching

A Rapid and Low-Cost Procedure for Fabrication of Glass Microfluidic Devices

Low-Cost Fabrication Strategies of Microfluidic Device on Glass Substrate

Fabrication of 1D nanofluidic channels on glass substrate by wet etching and room-temperature bonding