Fabrication of 1D nanofluidic channels on glass substrate by wet etching and room-temperature bonding

Qiaohong He,Shuang Chen,Yuan Su,Qun Fang,Hengwu Chen

DOI: https://doi.org/10.1016/j.aca.2008.08.040

IF: 6.911

2008-01-01

Analytica Chimica Acta

Abstract:In this paper, a simple and facile technique for fabricating one-dimensional (1D) glass nanofluidic chips was developed. Instead of using expensive nanolithography, the standard UV lithography and wet chemical etching technique was used to fabricate 1D nanochannels on a glass substrate. Smooth channel surfaces were obtained by adding HNO3 into conventional HF–NH4F etching solution. The calibrated etching rate of 3.6nmmin−1 was achieved using 1.5×10−2molL−1 HF–7.5×10−3molL−1 NH4F–7.5×10−3molL−1 HNO3 as etchant at 40°C. Inter-day preparation gave a R.S.D. of 6.8% in channel depth. The substrate was bonded with a glass cover plate at room temperature. A minimum aspect ratio (depth to width) of 5.0×10−5 for the nanochannels was achieved. The channel depth before bonding was measured by an a-surface profilometer, and the depth uniformity of nanochannels after bonding was demonstrated by cross-section scanning electron microscopy (SEM) analysis. With this technique, we successfully fabricated a nanofluidic device integrating nanochannel with microchannels and demonstrated the ion enrichment-depletion phenomena.