Abstract:FeTi‐Cu composites with varying Cu contents are subjected to high‐pressure torsion, and their deformation behavior is explored systematically using scanning electron microscopy, microhardness, and nanoindentation. The study identifies the limiting factors influencing the refinement during severe plastic deformation. The pronounced strength differences between phases lead to fragmentation primarily through hard‐hard (FeTi‐FeTi) contact points, promoted by homogeneous, i.e., non‐localized, and possibly turbulent material flow. These conditions are prevalent in Cu‐rich composites and during high‐temperature deformation. Conversely, Cu‐lean composites exhibit deformation localization, hindering the fragmentation process. Abrasion becomes an efficient refinement mechanism at the submicron‐/nano‐scale, particularly for composites containing higher concentrations of nanocrystalline FeTi and exhibiting homogeneous plastic deformation. Consequently, deformation localization in Cu‐lean composites inhibits both refinement mechanisms, while Cu‐rich compositions and higher temperatures result in efficient refinement but at the risk of coarsening at the nano‐scale. Refinement is localization‐limited in the former case and abrasion‐limited in the latter. Optimized processing conditions can overcome these constraints, yielding a uniform nanocomposite. This study sheds light on the intricate interplay of the mechanical properties of the respective phases in a composite, emphasizing the importance of tailored compositions and deformation conditions to optimize nanocomposites, particularly when dealing with challenging material pairings. This article is protected by copyright. All rights reserved.

Effect of Grain Refinement on the Comprehensive Mechanical Performance of W–Cu Composites

Effect of Microstructure Refinement on Surface Morphology and Dynamic Mechanical Properties of W-Cu Alloys

Microstructural studies of W–10wt.% Cu composites prepared by using ultrafine composite powder

Preparation and Properties of Fine-Grained and Ultrafine-Grained W-TiC-Y2O3 Composite

Excellent wear resistance of multicomponent nanocrystalline W‒Cu based composite

Study of a New Method to Fabricate W–Cu Composites

Performance of a Hierarchically Nanostructured W–Cu Composite Produced via Mediating Phase Separation

Multilayered W-Cu composites with enhanced strength, electrical conductivity and wear resistance

Insight into the Microstructure and Tensile Behavior of the W–Cu Composite Reinforced with Tungsten Fibers and Particulates

Wear-resistance enhancement of nanostructured W-Cu-Cr composites

Tribological and Electrochemical Corrosion Behaviors of Cu-based Powder Metallurgy Composites Reinforced by In-Situ WC with Different Morphology

Ultrafine W-Cu Composite Powder Research Progress

High hardness and wear resistance of W-Cu composites achieved by elemental dissolution and interpenetrating nanostructure.

Enhanced Mechanical and Electrical Properties of CuCrZr-WC Alloy Prepared by Mechanical Alloying and Spark Plasma Sintering

Multiphase strengthening mechanism of Cu-Y2O3/W composites prepared by mechanical alloying

Recent Advances in W–Cu Composites: A Review on the Fabrication, Application, Property, Densification, and Strengthening Mechanism

A Simple Approach to Obtaining Enhanced Mechanical Properties of Graphene/copper Composites with Heterogeneous Grain Structures

Exploring Refinement Characteristics in FeTi‐Cu x Composites: A Study of Localization and Abrasion Constraints

Microstructure and properties of W Cu composites reinforced by in-situ generated WC

Fabrication of W–Cu Functionally Graded Material with Improved Mechanical Strength

The influence of mechanical milling on microstructure and the properties of W-40Cu composite by hot extrusion