Abstract:In order to solve problems of significant interfacial reactions and agglomeration in graphene reinforced W-Cu composites, powders of copper coated graphene (Cu@Gr) were pre-mechanically mixed with tungsten and copper powders, and then graphene doped W-Cu composites were sintered using two different methods, e.g., spark plasma sintering (SPS) and infiltration sintering. Microstructural analysis showed that the doped Cu@Gr powder can effectively inhibit the interfacial reaction between graphene and tungsten, prevent the segregation of graphene, and evenly distribute the copper in the binder phase. When the mixed concentration of Cu@Gr was 0.45 wt%, uniform distributions of W phase and Cu phase were obtained in the composite, and the mechanical properties and conductivity of this composite achieved their best results. When the doping content was further increased to 0.8%, WC phase was found in all alloys, thus resulting in poor mechanical and physical properties. Comparing the microstructures produced using these two methods, the composites prepared using the infiltration sintering method showed network distribution of copper phase and segregation of copper, whereas the composites prepared using the SPS method showed network skeleton phase of tungsten. Although the SPS process was performed in a much shorter time, the mechanical properties of the composites sintered using the SPS process did not show much differences with those sintered using the infiltration sintering method.

Study of a New Method to Fabricate W–Cu Composites

Fabrication of Cu-riched W-Cu composites by combustion synthesis and melt-infiltration in ultrahigh-gravity field

Fabrication of 60 wt%W-40 wt%Cu composite with crystal orientation by combustion synthesis and melt-infiltration in ultrahigh-gravity field

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

In Suit Synthesis and Bonding of Cu to W–Cu Composite by Combustion Synthesis and Centrifugal Infiltration

W–Cu Composite with High W Content Prepared by Grading Rounded W Powder with Narrow Particle Size Distribution

Microstructure and high-temperature mechanical properties of Cu-W composite prepared by hot isostatic pressing

Effect of sintering temperature on fine-grained Cu W composites with high copper

Effect of Grain Refinement on the Comprehensive Mechanical Performance of W–Cu Composites

Fabrication of W–Cu Functionally Graded Material with Improved Mechanical Strength

Enhanced mechanical properties and thermal conductivity of W-30Cu composite fabricated with monodisperse and nearly spherical W powder

W-Cu Composites Reinforced by Copper Coated Graphene Prepared Using Infiltration Sintering and Spark Plasma Sintering: A Comparative Study

Interfacial Failure Mechanism in Tungsten Fiber Reinforced Copper-Based Composites Fabricated by Combustion Synthesis Melt Infiltration under Ultra-High Gravity

Fast fabrication of W-Cu functionally graded material by high-gravity combustion synthesis and melt-infiltration

In-situ synthesis of core-shell structure W(WC) composite grains in W-Cu composites fabricated by infiltration

Preparation and Properties of Fine-Grained and Ultrafine-Grained W-TiC-Y2O3 Composite

Microstructure and Properties of W Cu Composites with Low Copper Content at Different Sintering Temperatures

High-gravity Combustion Synthesis of W-Cr Alloys with Improved Hardness

The effects of ultrasonic vibration on mechanical properties of tungsten particle-reinforced copper-matrix composites

Effect of nano-Y2O3 on the microstructure and mechanical properties of Cu-10W composites prepared by spark plasma sintering

Preparation of Tungsten Fiber Reinforced-Tungsten/copper Composite for Plasma Facing Component