Abstract:In order to solve problems of significant interfacial reactions and agglomeration in graphene reinforced W-Cu composites, powders of copper coated graphene (Cu@Gr) were pre-mechanically mixed with tungsten and copper powders, and then graphene doped W-Cu composites were sintered using two different methods, e.g., spark plasma sintering (SPS) and infiltration sintering. Microstructural analysis showed that the doped Cu@Gr powder can effectively inhibit the interfacial reaction between graphene and tungsten, prevent the segregation of graphene, and evenly distribute the copper in the binder phase. When the mixed concentration of Cu@Gr was 0.45 wt%, uniform distributions of W phase and Cu phase were obtained in the composite, and the mechanical properties and conductivity of this composite achieved their best results. When the doping content was further increased to 0.8%, WC phase was found in all alloys, thus resulting in poor mechanical and physical properties. Comparing the microstructures produced using these two methods, the composites prepared using the infiltration sintering method showed network distribution of copper phase and segregation of copper, whereas the composites prepared using the SPS method showed network skeleton phase of tungsten. Although the SPS process was performed in a much shorter time, the mechanical properties of the composites sintered using the SPS process did not show much differences with those sintered using the infiltration sintering method.

Fabrication of Cu-riched W-Cu composites by combustion synthesis and melt-infiltration in ultrahigh-gravity field

Study of a New Method to Fabricate W–Cu Composites

Fabrication of 60 wt%W-40 wt%Cu composite with crystal orientation by combustion synthesis and melt-infiltration in ultrahigh-gravity field

In Suit Synthesis and Bonding of Cu to W–Cu Composite by Combustion Synthesis and Centrifugal Infiltration

Achieving Homogeneous Fe Distribution and High Strength in Cu-Fe Composite Consolidated by Powder Rolling

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Fabrication of W–Cu Functionally Graded Material with Improved Mechanical Strength

Fast fabrication of W-Cu functionally graded material by high-gravity combustion synthesis and melt-infiltration

W–Cu Composite with High W Content Prepared by Grading Rounded W Powder with Narrow Particle Size Distribution

Interfacial Failure Mechanism in Tungsten Fiber Reinforced Copper-Based Composites Fabricated by Combustion Synthesis Melt Infiltration under Ultra-High Gravity

Microstructure and high-temperature mechanical properties of Cu-W composite prepared by hot isostatic pressing

Microstructure and Properties of W Cu Composites with Low Copper Content at Different Sintering Temperatures

In-situ synthesis of core-shell structure W(WC) composite grains in W-Cu composites fabricated by infiltration

High-gravity Combustion Synthesis and in Situ Melt Infiltration: A New Method for Preparing Cemented Carbides

Novel low temperature derived W f /W-ZrC-Cu composites by reactive infiltration with enhanced mechanical and thermal physical properties

Enhanced mechanical properties and thermal conductivity of W-30Cu composite fabricated with monodisperse and nearly spherical W powder

Preparation of Tungsten Fiber Reinforced-Tungsten/copper Composite for Plasma Facing Component

W-Cu Composites Reinforced by Copper Coated Graphene Prepared Using Infiltration Sintering and Spark Plasma Sintering: A Comparative Study

Preparation of bulk Cu-W interpenetrating-phase composites by liquid metal dealloying

Performance of a Hierarchically Nanostructured W–Cu Composite Produced via Mediating Phase Separation

Freeze-casted tungsten skeleton reinforced copper matrix composites