Abstract:W/CuCrZr alloy composite panels are promising plasma-facing components for use in future nuclear-fusion reactors. However, the intrinsic immiscibility of W and Cu makes joining them difficult. In this study, we developed a vacuum diffusion bonding method that involves sandblasting of the W substrate surface, Cu electroplating and annealing, and subsequent vacuum diffusion bonding to realize W/CuCrZr joints with high bond strength. The morphologies and structures of the W and W/CuCrZr joints were investigated by scanning electron microscopy, X-ray diffraction, and high-resolution transmission electron microscopy. Sandblasting was found to induce the plastic deformation, roughening, and grain refinement of the W substrate surface. During Cu plating on the surface of the sandblasted W (and subsequent annealing), the Cu layer was embedded in micron-scale irregular pits on the sandblasted W surface, creating a tight bond. The shear bond strength (184 MPa) and bonding quality of a W/CuCrZr joint obtained with the sandblasting/Cu interlayer method was superior to those of a W/CuCrZr joint prepared by conventional vacuum diffusion bonding. The structural origins of this superior W/CuCrZr joint were related to a region of W and Cu interdiffusion with a thickness of approximately 30 nm. This improved vacuum diffusion bonding method for W and CuCrZr can facilitate the development of plasma-facing components for future nuclear-fusion devices. (c) 2021 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).

In Suit Synthesis and Bonding of Cu to W–Cu Composite by Combustion Synthesis and Centrifugal Infiltration

Fabrication of Cu-riched W-Cu composites by combustion synthesis and melt-infiltration in ultrahigh-gravity field

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Study of a New Method to Fabricate W–Cu Composites

Fabrication of 60 wt%W-40 wt%Cu composite with crystal orientation by combustion synthesis and melt-infiltration in ultrahigh-gravity field

Preparation of bulk Cu-W interpenetrating-phase composites by liquid metal dealloying

Bonding W and W-Cu composite with an amorphous W-Fe coated copper foil through hot pressing method

Interfacial Failure Mechanism in Tungsten Fiber Reinforced Copper-Based Composites Fabricated by Combustion Synthesis Melt Infiltration under Ultra-High Gravity

High-strength Vacuum Diffusion Bonding of Cu-plated, Sandblasted W and CuCrZr Alloy

Novel synthesis of CuW composite reinforced with lamellar precipitates via aluminothermic reduction

Fast fabrication of W-Cu functionally graded material by high-gravity combustion synthesis and melt-infiltration

Preparation of Tungsten Fiber Reinforced-Tungsten/copper Composite for Plasma Facing Component

Microstructure and high-temperature mechanical properties of Cu-W composite prepared by hot isostatic pressing

Effect of sintering temperature on fine-grained Cu W composites with high copper

Performance of a Hierarchically Nanostructured W–Cu Composite Produced via Mediating Phase Separation

Bonding Tungsten, W–Cu-alloy and Copper with Amorphous Fe–W Alloy Transition

In-situ synthesis of core-shell structure W(WC) composite grains in W-Cu composites fabricated by infiltration

Formation Mechanism of W-coated Cu Composite Powders and the Metal Injection Molding Using Polyoxymethylene-Based Binders

Interfacial evolution mechanism of W/Cu explosive welding interface affected by preheating

Fabrication and microstructure of W-Cu composites prepared from Ag-coated Cu powders by electroless plating

Microstructure and mechanical properties of W/Cu vacuum diffusion bonding joints using amorphous Fe–W alloy as interlayer