Abstract:Closing resistors can effectively restrict switching surges due to closing no load transmission lines of EHV and/or UHV AC power grids.In view of complex structure and high cost of closing resistors,it is worthy to research that whether there is the necessity to adopt this measure or not.By use of software simulation,the applicability of closing resistors in EHV and UHV AC power grids under different conditions is researched.Research results show that for 500 kV AC power grid the closing resistor can usually be not equipped while the length of transmission line is short than 100 km;whether closing resistor has to be equipped or not should be determined according to the analysis results based on concrete conditions while the length of transmission line is within the range from 100 km to 200 km;the closing resistor should be adopted in general while the length of transmission line is within the range from 200 km to 400 km,however,the way of configuring two or three sets of metal oxide arrester(MOA) along the transmission line to substitute for closing resistors could be adopted;the closing resistors should be still equipped to restrict switching surge while the length of transmission line is within the range from 400 km to 600 km.As for 1000 kV AC power grid,it is hardly to restrict the switching surge due to closing no-load line to the specified value given by the code even though the length of transmission line is 100 km when closing resistors are not adopted.Thus,in general closing resistors should be configured in 1000 kV transmission lines,and it is better to adopt closing resistors with low resistance values for longer transmission lines and that with high resistance values for shorter transmission line.

Statistical analysis of switching overvoltages in UHV transmission lines with a controlled switching

Simulation On Power Characteristic Of Uhvdc During Commutation Failure And Dc Block

Study on Applicability of Circuit Breaker Closing Resistance in EHV and UHV AC Systems

Study on Switching Over-voltage and Its Restrictions in UHVAC System

Comparative Study on Measures to Limit Load-Rejection Opening Overvoltage of Long-Distance and Large-Capacity UHVAC Transmission Lines

Switching Overvoltage Characteristics of <formula Formulatype="inline"><tex Notation="TeX">$\pm $&Lt;/tex></formula>1100-Kv UHVDC Converter Station

DC switching overvoltage of ± 1100 kV UHVDC converter station

Research on switching overvoltage in 1000 kV ultra-HVAC transmission line

Failure Risk of UHV AC Transmission Line Considering the Statistical Characteristics of Switching Overvoltage Waveshape

Comparison of Insulation Coordination Between ±800kv and ±1100kv UHVDC Systems

Research on Power Frequency Over-Voltage in UHV AC Transmission Lines

Simulation on lightning overvoltage of ±800kV converter station

Research on Switching Overvoltage Caused by Faults in 1000kV UHV AC Transmission Line

Research on Unloaded Switching into Fault Protection for UHV Transmission Line

Study on Transient Overvoltage of Zhexi Converter Station of ±800 Kv DC Power Transmission Project

Deep Suppression of Switching Overvoltages in AC UHV Systems Using Low Residual Arresters

Study on reliability improvement of current-transferring type HVDC circuit breaker

Research on Overvoltage Suppression by Blocking Diode and DC Circuit Breaker in LCC-VSC Hybrid HVDC System.

Study on overvoltage and insulation coordination of DC filter for ±800 kV UHVDC project from Xiangjiaba to Shanghai

Elimination of closing resistors for breakers in 1000-kV UHV system by surge arresters

Switching Transient of 1000-Kv UHV System Considering Detailed Substation Structure