Abstract:Now 1000-kV ac ultra-high voltage transmission line has been put into operation in China, the transmission tower reaches about 70 m to 90 m high, and 30 m to 60 m wide. So, the 1000-kV transmission line has a wide lightning induced area. On the other hand, the operation voltage is very high, all these increase the probability of lightning striking UHV transmission lines. Due to insulation level of the 1000-kV transmission line is very high, so the threaten of direct lightning stroke is very small, but the high towers increase the shielding failure probability. In this paper, we proposed a numerical model to analyze the shielding failure characteristics of 1000- kV ac transmission line with the lightning leader propagation process considered, the electrical field of the system including lightning leader, transmission line and ground is solved. According to analysis results, we found if the span between two overhead ground wires of transmission line is too wide, a new phenomenon of middle-phase shielding failure takes place, the downward lightning leader of current magnitude higher than 100 kA would strike the middle phase conductor bypassing the ground wires. The middle-phase shielding failure is caused by the very high operation voltage of 1000-kV ultra-high voltage transmission line and wide designed span between two ground wires. The mechanism to generate this phenomenon is different from that of small lightning current, and the EGM can not properly explain this phenomenon. For the cat-head tower, the high shielding failure probability is caused by the middle-phase shielding failure, but for the cup tower, the shielding failure mainly takes place on the side phases. At last, the related measures to improve the lightning performances of 1000-kV ultra-high voltage transmission line are discussed. Three ground wires had been applied in the 2 km section of 1000-kV Jindongnan-Nayang transmission-line near the 1000-kV substation.

Failure Risk of UHV AC Transmission Line Considering the Statistical Characteristics of Switching Overvoltage Waveshape

Simulation On Power Characteristic Of Uhvdc During Commutation Failure And Dc Block

Simulated Calculation and Analysis of Lightning Performance of UHV A.C. Transmission Line

Research on Power Frequency Over-Voltage in UHV AC Transmission Lines

Switching Overvoltage Characteristics of <formula Formulatype="inline"><tex Notation="TeX">$\pm $&Lt;/tex></formula>1100-Kv UHVDC Converter Station

Research on switching overvoltage in 1000 kV ultra-HVAC transmission line

DC switching overvoltage of ± 1100 kV UHVDC converter station

Applicable occasions of UHVAC/UHVDC transmission and their technology comparisons in China

Study on overvoltage and insulation coordination of DC filter for ±800 kV UHVDC project from Xiangjiaba to Shanghai

Study on Switching Over-voltage and Its Restrictions in UHVAC System

On the DC Transient Overvoltage in the Converter Stations of ±800 Kv Xiluodu Zhexi HVDC Project

Comparative Research on Z-Type Tower and Traditional T-Type Tower for UHVDC Transmission Lines Located at Mountain Areas

Statistical analysis of switching overvoltages in UHV transmission lines with a controlled switching

Comparative Study on Measures to Limit Load-Rejection Opening Overvoltage of Long-Distance and Large-Capacity UHVAC Transmission Lines

Lightning shielding failure analysis of 1000-kV ultra-high voltage ac transmission line

Switching Transient of 1000-Kv UHV System Considering Detailed Substation Structure

Research on lightning intruding waves in 220 kV GIS substation

Research on Switching Overvoltage Caused by Faults in 1000kV UHV AC Transmission Line

Research on Converter Valve Overvoltage Mechanism and Calculation Conditions of ± 800 Kv Converter Station

Study on the Calculation of Shielding Failure for Dc Transmission Lines

Study on Transient Overvoltage of Zhexi Converter Station of ±800 Kv DC Power Transmission Project