Abstract:Yttria-stabilized zirconia (YSZ) thin films on polycrystalline substrates were grown by cold-wall aerosol-assisted metallorganic chemical vapor deposition (MOCVD) at the temperatures of 673-1233 K using metal beta-diketonate chelates as precursors. Thin uniform films with amorphous structure were obtained below 673 K; when the deposition temperature increases to 773-1023 K, YSZ films appear to be a mixture of cubic and monoclinic phases; single cubic YSZ phase can be obtained at deposition temperature above 1023 K. The Y/Zr atom ratio estimated from the corresponding X-ray photoelectron spectroscopy peaks is less than the feed ratio, which can be interpreted by different transfer resistance of Y and Zr intermediates diffusing to the substrate surface. The films obtained at 673-1023 K possess a layer structure originated from low mobility of the absorbed species. Along with the increase of the deposition temperature, the grains become mature and larger, and then unite with each other to form a continuous columnar film. Mass transport dominates the growth process within lower temperatures, and homogeneous reaction will interrupt the growth at increasingly high temperatures. Growth rate expression with respect to temperature, pressure, gas flow rate, and metal concentration of precursor solutions was deduced assuming deposition of mass-transport limited mechanism, which is consistent with the experimental results. (c) 2005 The Electrochemical Society. All rights reserved.

Fabrication Of Y2o3-Stablized Zro2 Ultrathin Film By Newly Developed Component-Controllable Langmuir-Blodgett Method

Fabrication and Characterization of Y2O3 Stabilized ZrO2 Films Deposited with Aerosol-Assisted MOCVD

Formation and Rate Processes of Y2o3 Stabilized Zro2 Thin Films from Zr(Dpm)(4) and Y(Dpm)(3) by Cold-Wall Aerosol-Assisted Mocvd

Formation and Rate Processes of Y[sub 2]o[sub 3] Stabilized ZrO[sub 2] Thin Films from Zr(DPM)[sub 4] and Y(DPM)[sub 3] by Cold-Wall Aerosol-Assisted MOCVD

Deposition of Y2O3 stabilized ZrO2 thin films from Zr(DPM)4 and Y(DPM)3 by aerosol-assisted MOCVD

Preparation Of Y2o3-Stabilized Zro2 Thin Electrolyte Films From Langmuir-Blodgett Film Precursors By Means Of Surface Ions

Synthesis of YSZ film by solid single source PE-MOCVD method and characterization

Zro2 and Ysz Thin-Films Synthesized by Microwave Plasma Cvd Process

Deposition and Characterization of YSZ Thin Films by Aerosol-Assisted CVD

Preparation of epitaxial yttria-stabilized zirconia with non-quilibrium t' phase and ferroelastic domain by pulsed laser deposition

Improvement of Surface Morphology of Yttrium-Stabilized Zirconia Films Deposited by Pulsed Laser Deposition on Rolling Assisted Biaxially Textured Substrate Tapes

Research on YSZ thin films prepared by plasma-CVD process

Fabrication of YSZ Thin Films from Suspension by Electrostatic Spray Deposition

Insitu Fabrication Of Ybco/Ysz/Si Thin-Films By Laser Ablation

Langmuir-Blodgett Ultrathin Films Composed of Zno Nanoparticles: Fabrication and Characterization

From zirconia to yttria: Sampling the YSZ phase diagram using sputter-deposited thin films

Control of Self-assembled Particles on Thin YSZ Film Deposited by PLD

Preparation of Yttria-Stabilized Zirconia(ysz)films by an Electrophoretic Deposition Method

The fabrication technique of YSZ electrolyte film

Epitaxial growth of YSZ buffer layer for YBa2Cu3O7-δ coated conductor by reel to reel pulsed laser deposition

Fabricating Component-controlled LB Films by Means of "surface Ions" Technique