Abstract:We present the detailed dc and radio-frequency characteristics of an $\hbox{Al}_{0.3}\hbox{Ga}_{0.7}\hbox{N/GaN/In}_{0.1}\hbox{Ga}_{0.9}\hbox{N/GaN}$ double-heterojunction HEMT (DH-HEMT) structure. This structure incorporates a thin (3 nm) $\hbox{In}_{0.1}\hbox{Ga}_{0.9}\hbox{N}$ notch layer inserted at a location that is 6-nm away from the AlGaN/GaN heterointerface. The $\hbox{In}_{0.1}\hbox{Ga}_{0.9}\hbox{N}$ layer provides a unique piezoelectric polarization field which results in a higher potential barrier at the backside of the two-dimensional electron gas channel, effectively improving the carrier confinement and then reducing the buffer leakage. Both depletion-mode (D-mode) and enhancement-mode (E-mode) devices were fabricated on this new structure. Compared with the baseline AlGaN/GaN HEMTs, the DH-HEMT shows lower drain leakage current. The gate leakage current is also found to be reduced, owing to an improved surface morphology in InGaN-incorporated epitaxial structures. DC and small- and large-signal microwave characteristics, together with the linearity performances, have been investigated. The channel transit delay time analysis also revealed that there was a minor channel in the InGaN layer in which the electrons exhibited a mobility slightly lower than the GaN channel. The E-mode DH-HEMTs were also fabricated using our recently developed $\hbox{CF}_{4}$-based plasma treatment technique. The large-signal operation of the E-mode GaN-based HEMTs was reported for the first time. At 2 GHz, a $\hbox{1} \times \hbox{100}\ \mu\hbox{m}$ E-mode device demonstrated a maximum output power of 3.12 W/mm and a power-added efficiency of 49% with single-polarity biases (a gate bias of $+$0.5 V and a drain bias of 35 V). An output third-order interception point of 34.7 dBm was obtained in the E-mode HEMTs.

Monolithic integration of GaN-based micromechanical resonators and HEMTs for timing applications

Spacer Side-wall Processed 0.15 Μm GaN HEMT for Ka-band Application

On the Integration of AlGaN/GaN HEMT and Micro-Electro-Mechanical Systems (MEMS) For Biomedical Applications: A Review

High frequency guided mode resonances in mass-loaded, thin film gallium nitride surface acoustic wave devices

A Generalized Cmos-Mems Platform For Micromechanical Resonators Monolithically Integrated With Circuits

AlN/GaN/InGaN Coupling-Channel HEMTs for Improved g m and Gain Linearity

Integration of Ferroelectrics with III-N Transistors for High Performance Millimeter-Wave Applications

A GaN Power Integration Platform Based on Engineered Bulk Si Substrate with Eliminated Crosstalk Between High-Side and Low-Side HEMTs

GaN Micromechanical Resonators with Meshed Metal Bottom Electrode

Monocrystalline AlGaAs heterostructures for high-reflectivity high-Q micromechanical resonators in the MHz regime

Flexible Integration of Gigahertz Nanomechanical Resonators with a Superconducting Microwave Resonator using a Bonded Flip-Chip Method

Scaled Self-Aligned N-Polar GaN/AlGaN MIS-HEMTs with $f_{t}$ of 275 GHz

DC and RF Characteristics of AlGaN/GaN/InGaN/GaN Double-Heterojunction HEMTs

GaN HEMTs on Low Resistivity Si Substrates with Thick Buffer Layers for RF Signal Amplification and Power Conversion

Gallium nitride phononic integrated circuits for future RF front-ends

Performance analysis of InAlN/GaN HEMT and optimization for high frequency applications

Evaluation of Power and Linearity at 30 GHz in AlGaN/GaN HEMT Fabricated by Integrating Transistors With Multiple Threshold Voltages

Development of GaN HEMTs Fabricated on Silicon, Silicon-on-Insulator, and Engineered Substrates and the Heterogeneous Integration

Current collapse suppression in AlGaInN/GaN HEMTs with thin unintentionally doped GaN channel and AlN back barrier grown on single-crystal AlN substrate

High-frequency traveling-wave phononic cavity with sub-micron wavelength

Monolithic Integration of Nano-Ridge Engineered InGaP/GaAs HBTs on 300 mm Si Substrate