DC and RF Characteristics of AlGaN/GaN/InGaN/GaN Double-Heterojunction HEMTs

Jie Liu,Yugang Zhou,Jia Zhu,Yong Cai,Kei May Lau,Kevin J. Chen

DOI: https://doi.org/10.1109/ted.2006.887045

IF: 3.1

2007-01-01

IEEE Transactions on Electron Devices

Abstract:We present the detailed dc and radio-frequency characteristics of an $\hbox{Al}_{0.3}\hbox{Ga}_{0.7}\hbox{N/GaN/In}_{0.1}\hbox{Ga}_{0.9}\hbox{N/GaN}$ double-heterojunction HEMT (DH-HEMT) structure. This structure incorporates a thin (3 nm) $\hbox{In}_{0.1}\hbox{Ga}_{0.9}\hbox{N}$ notch layer inserted at a location that is 6-nm away from the AlGaN/GaN heterointerface. The $\hbox{In}_{0.1}\hbox{Ga}_{0.9}\hbox{N}$ layer provides a unique piezoelectric polarization field which results in a higher potential barrier at the backside of the two-dimensional electron gas channel, effectively improving the carrier confinement and then reducing the buffer leakage. Both depletion-mode (D-mode) and enhancement-mode (E-mode) devices were fabricated on this new structure. Compared with the baseline AlGaN/GaN HEMTs, the DH-HEMT shows lower drain leakage current. The gate leakage current is also found to be reduced, owing to an improved surface morphology in InGaN-incorporated epitaxial structures. DC and small- and large-signal microwave characteristics, together with the linearity performances, have been investigated. The channel transit delay time analysis also revealed that there was a minor channel in the InGaN layer in which the electrons exhibited a mobility slightly lower than the GaN channel. The E-mode DH-HEMTs were also fabricated using our recently developed $\hbox{CF}_{4}$-based plasma treatment technique. The large-signal operation of the E-mode GaN-based HEMTs was reported for the first time. At 2 GHz, a $\hbox{1} \times \hbox{100}\ \mu\hbox{m}$ E-mode device demonstrated a maximum output power of 3.12 W/mm and a power-added efficiency of 49% with single-polarity biases (a gate bias of $+$0.5 V and a drain bias of 35 V). An output third-order interception point of 34.7 dBm was obtained in the E-mode HEMTs.

engineering, electrical & electronic,physics, applied