Abstract:Non-agglomerated nano-sized BaTiO3 powders were prepared by a 3 step decomposition of barium titanyl citric acid chelate derived from Ba(NO3)2-TiO(NO3)2-citric acid-NH4NO3 based complex compound system. The 1st step was the thermal treatment of chelate wet gel at 150°C for 40min to remove water and non-bridging hydroxyl groups and to form expanded gel intermediate. The 2nd step was the decomposition of the organic fuel by igniting expanded gel intermediate at 300°C. The 3rd step was the formation of the high purity BaTiO3 by calcining the decomposed powders at 700°C for 2 hours. The most expanded gel intermediate was found to be a decisive factor for the elimination of hard agglomerate. In addition, the initial oxidant/fuel molar ratio was shown to strongly influence the characteristics of the powders thus obtained. The optimum oxidant/fuel value was 3 for obtaining non-agglomerated pure BaTiO3 powders with a particle size of 50 nm. The agglomerate degree of BaTiO3 powders was determined by particle morphology and uniformity of the green compact microstructure observed by field emission scanning electron microscopy and scanning electron microscope.

Gelation and heat treatment of preparing BaNd2Ti5O14 with autocombustion methods

Gelation and Heat Treatment of Preparing BaNd2Ti5O14with Autocombustion Methods

Gelation and heat treatment of preparing BaNc-4TisO-4 with îAutocombustion methods

The Characterization and Preparation of Nano-Scale Fe Doping Tio2 by Sol-Gel Method (I) - the Crystallization and Thermal Decomposition Process of Fe Doping Tio2 Xerogel Powders Using Thermal Tg-Ir Spectrometry

Preparation and Heat Treatment of Titania Aerogels by Ambient Pressure Drying

PREPARATION AND SINTERING PROPERTIES OF BaTi4O9 BY CITRIC ACID GEL METHOD

Comparison on the crystallization characteristics of sol–gel derived (BiDy)3Fe5O12 garnet film and powder

The Characterization And Preparation Of Nano-Scale Fe Doping Tio2 By Sol-Gel Method - (Ii) - The Crystal Character And Grain Growth Of Fe Doping Tio2 Xerogel Powders

Citric Acid Gel Method Synthesis, Characterization And Dielectric Properties Of Single-Phase Bati4o9

Preparation and characterization of ZnO-B2O3-SO2 by sol-gel method

Structure and Electrical Properties of BaTiO3 Prepared by Sol–gel Process

Investigation of heat treatment condition, ethylene glycol and deionized water effects on the phase structure of Ba0.6Sr0.4TiO3 nanoparticles produced by the sol-gel method

Preparation of Ti Doped BaFe12O19 Ceramics by a Sol-Gel Process

Preparation of Ba2Ti9O20 by gel self-propagation process

Characterization And Dielectric Properties Of Single-Phase Ba2ti9o20 Prepared By Citric Acid Gel Method

Process for Non-Agglomerated Nanometer-Sized Barium Titanate Powders by Sol-Gel Auto-Igniting Synthesis

Preparation and Characterization of ZnO-B2O3-SiO2 by Sol-Gel Method

Effects of Heat-Treatment Temperature on Preparation of the Sol-Gel-Derived Ag/TiO2 Films

Preparation of BaBi4Ti4O15 powder by sol-gel process

The Preparation of BaTi4O9 by Sol-Gel Method

Preparation and Sintering Behaviour of Nanostructured SrBi2Ta2O9ceramics