Abstract:The oxalate co-precipitation method was employed to synthesize nanocrystalline Ba0.4Sr0.6TiO3 having an average particle size of 100 nm. The conventional sintering (CS) and spark plasma sintering (SPS) methods were used to fabricate Ba0.4Sr0.6TiO3 ceramics with different microstructures. The SPS sample presented uniformly dense microstructure and ultrafine grains, while abnormal grain growth and some pores were discerned in the CS sample. The differences in microstructure significantly affected the dielectric properties and energy storage performance of the ceramics. The dielectric constant of the SPS sample was high (epsilon' (similar to)1200), its dielectric loss was low (tan delta (similar to)0.003), and the sample presented diffuse phase transition and high breakdown strength (E-b = 260 kV/cm) at room temperature. Compared with the CS sample, the maximum energy storage density and energy storage efficiency of the SPS sample were increased from 0.61 to 1.20 J/cm(3) and 72.6% to 91.6%, respectively. All results revealed that SPS is a powerful technique to produce dense ceramics with high energy storage performance.

Characterization And Dielectric Properties Of Single-Phase Ba2ti9o20 Prepared By Citric Acid Gel Method

Citric Acid Gel Method Synthesis, Characterization And Dielectric Properties Of Single-Phase Bati4o9

PREPARATION AND SINTERING PROPERTIES OF BaTi4O9 BY CITRIC ACID GEL METHOD

The Characterization and Preparation of Nano-Scale Fe Doping Tio2 by Sol-Gel Method (I) - the Crystallization and Thermal Decomposition Process of Fe Doping Tio2 Xerogel Powders Using Thermal Tg-Ir Spectrometry

Preparation and Characterization of Nano-Crystalline Ba3Ti4Nb4O21 Microwave Dielectric Ceramic Powder

A Study on CSC-derived Ba 2 Ti 9 O 20 Phase Formation and Its Dielectric Property

Structure and Electrical Properties of BaTiO3 Prepared by Sol–gel Process

Improved Energy Storage Performance of Ba0.4Sr0.6TiO3 Nanocrystalline Ceramics Prepared by Using Oxalate Co-Precipitation and Spark Plasma Sintering

Preparation of Ba2Ti9O20 by gel self-propagation process

Preparation of Ti Doped BaFe12O19 Ceramics by a Sol-Gel Process

Dielectric Properties of BaTiO3 Based Ceramics Prepared from Nano-powders

Morphology Evolution of BaTi5O11 Nanocrystals Prepared by Hydrothermal Method and Their Permittivity

Synthesis of BaTi2O5 Nanopowders by Sol–Gel Method and the Dielectric Properties of the Ceramics

Preparation and Characterization of Citrate Sol-Gel Derived Ba(Zr,Ti)O3 Ceramics with Al2O3 Addition

Preparation and Dielectric Properties of (ca0.61,nd0.26)tio3 Nanoparticles by a Sol–gel Method

Gelation and heat treatment of preparing BaNd2Ti5O14 with autocombustion methods

Citrate Solution Combustion Derived Ba2Ti9O20 Ceramics

Gelation and Heat Treatment of Preparing BaNd2Ti5O14with Autocombustion Methods

Synthesis of Nanocrystalline 0.94Bi<sub>0.5</sub>Na<sub>0.5</sub>TiO<sub>3</sub>-0.06BaTiO<sub>3</sub> Powder by a Citrate Method

Synthesis and performance of tetragonal Ca2+ doped BaTiO3 fine powders

Comparison of Characteristics of BaTiO<sub>3</sub> Prepared by Different Process