Abstract:The Nb and Co doped barium titanate was synthesized by sol-gel auto-ignition synthesis process (abbreviated SAS) and compared with the doped powder of the same composition prepared by conventional ball milling process. The phase structure, morphology of the two as-obtained powders and correlative dielectric properties of sintered BaTiO3-based ceramics were measured. The XRD analysis demonstrated that the SAS powder was the Ba(M0.047Ti0.953)O3(M=Nb, Co) solid solution based on BaTiO3; it further suggested that Nb and Co cations could replace the Ti ions and reach reciprocal balance of acceptors and donors during the decomposition step of the organic fuel by igniting the dried gel. TEM observation showed that the Ba(M0.047Ti0.953)O3(M=Nb, Co) particles were spherical with the size ranged from 30 to 110nm. Furthermore, it was found that the value of the Curie temperature of both the doped powders was being lowered in comparison with pure BaTiO3 (Tc≈128°C ); and the dielectric constant at room temperature of the SAS powder was 5840, which was much higher than that of the conventional ball milling doped powder(3013). It was attributed to the maximum homogeneous distribution of dopants in Ba-Ti initial solution at atomic level via the SAS process.

Synthesis of BaTi2O5 Nanopowders by Sol–Gel Method and the Dielectric Properties of the Ceramics

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

Citric Acid Gel Method Synthesis, Characterization And Dielectric Properties Of Single-Phase Bati4o9

Structure and Electrical Properties of BaTiO3 Prepared by Sol–gel Process

Dielectric Properties of BaTiO3 Based Ceramics Prepared from Nano-powders

Preparation of Ti Doped BaFe12O19 Ceramics by a Sol-Gel Process

Improved Energy Storage Performance of Ba0.4Sr0.6TiO3 Nanocrystalline Ceramics Prepared by Using Oxalate Co-Precipitation and Spark Plasma Sintering

Synthesis and properties study of BaTi0.95Sc0.05O3-δ nanopowders and ceramics

The Effect of B2o3-Li2co3 Addition on Sintering Behavior and Dielectric Properties of Ba0.6sr0.4tio3 Ceramics

Preparation and Dielectric Properties of (ca0.61,nd0.26)tio3 Nanoparticles by a Sol–gel Method

Sol‐Gel Routes to Nanostructured Patterned Ferroelectric Thin Films with Novel Electronic and Optical Functions

Enhanced Energy Storage Properties of Barium Strontium Titanate Ceramics Prepared by Sol-Gel Method and Spark Plasma Sintering

Synthesis of Nanocrystalline 0.94Bi<sub>0.5</sub>Na<sub>0.5</sub>TiO<sub>3</sub>-0.06BaTiO<sub>3</sub> Powder by a Citrate Method

Room temperature synthesis of BaTiO3 nanoparticles using titanium bis(ammonium lactato) dihydroxide

Sol–gel synthesis, densification, and electrical properties of CuO–B 2 O 3 doped Ba 6−3 x R 8+2 x Ti 18 O 54 (R = Nd) microwave dielectric ceramics

Preparation and Dielectric Properties of the Nb and Co Doped Barium Titanate by Sol-Gel Auto-Ignition Synthesis Process

Synthesis and Microstructure Characterization of Gd- and Sc- Codoped Batio3 Nanopowders Via Sol-Gel Method

Ferroelectric properties and microwave sintering of BaTiO3 synthesized by using the alkoxide-hydroxide sol-gel process

Sol–gel Synthesis and Characterization of Ba(1−x)SrxTiO3 Ceramics

The Influence of the Synthesis Method on the Characteristics of BaTiO3

Polymorphism and Dielectric Properties of Sc-doped BaTiO3 Nanopowders Synthesized by Sol–gel Method