Enhanced Energy Storage Properties of Barium Strontium Titanate Ceramics Prepared by Sol-Gel Method and Spark Plasma Sintering

Yu Hui Huang,Yong Jun Wu,Juan Li,Bing Liu,Xiang Ming Chen
DOI: https://doi.org/10.1016/j.jallcom.2017.01.150
IF: 6.2
2017-01-01
Journal of Alloys and Compounds
Abstract:Dense Ba(0.4)Sr(0.6)TiO(3)ceramics with fine grains and uniform microstructure were prepared by sol-gel method and spark plasma sintering (SPS). The dielectric properties, microstructures, and energy storage performance of spark plasma sintered Ba(0.4)Sr(0.6)TiO(3)ceramics were evaluated. FineBa(0.4)Sr(0.6)TiO(3) powders were synthesized by sol-gel method at above 750 degrees C. SPS technique showed its advantages in suppressing exaggerated grain growth and increasing the relative density of Ba(0.4)Sr(0.6)TiO(3)ceramics. Diffuse phase transition and nearly linear P-E behavior were observed in all samples. Moderate dielectric constant (similar to 960), low dielectric loss (similar to 0.003), high electrical breakdown strength (similar to 240 kV/cm), significantly enhanced energy storage density (similar to 1.23 J/cm3) and ultrahigh energy storage efficiency (similar to 94.52%) were obtained in Bao,4Sr06TiO3 ceramics by using sol-gel method and spark plasma sintering. (C) 2017 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?