Abstract:Dielectric (Ba0.4Sr0.6)TiO3 (BST) ceramics are promising dielectric energy storage materials due to their moderate dielectric constant, low dielectric loss, and slight nonlinearity. However, their energy density is limited by their low breakdown strength (BDS). In this study, we aimed to address this limitation by incorporating various amounts of Bi0.2Sr0.7(Mg1/3Nb2/3)O3 (SBMN) into the BST matrix. The (1–x)BSTxSBMN ceramics were prepared by conventional solid-state sintering, resulting in single-phase solid solutions. Compared to pure BST ceramics, the (1–x)BST–xSBMN ceramics exhibited lower remnant polarization and significantly enhanced BDS. Furthermore, the relaxation of the ceramics enhanced with increasing doping concentration, with an efficiency of η = 94.0% achieved at x = 0.20. Among them, the breakdown field strength of 0.85BST–0.15SBMN ceramics was 597 kV cm−1, achieving a recoverable energy storage density of Wrec = 2.81 J cm−3 and an efficiency of η = 90.8% under an external electric field of 480 kV cm−1. Subsequent tests revealed that the introduction of SBMN not only increased the band gap and conduction activation energy of the material, leading to an increase in BDS, but also promoted the formation of polar nanoregions (PNRs) which contributed to boosted energy efficiency, resulting in a significant enhancement in the energy storage performance of BST ceramics.

Energy Storage Properties of Ultra Fine-Grained Ba0.4Sr0.6TiO3-based Ceramics Sintered at Low Temperature

Improved Energy Storage Performance of Ba0.4Sr0.6TiO3 Nanocrystalline Ceramics Prepared by Using Oxalate Co-Precipitation and Spark Plasma Sintering

Enhanced low electric-field energy-storage performance in Ba0.9Sr0.1TiO3-Bi(Mg1/2Ti1/2)O-3 ceramics

Enhanced Dielectric Strength and Energy Storage Density in BaTi 0.7 Zr 0.3 O 3 Ceramics Via Spark Plasma Sintering

Grain Size Effect and Microstructure Influence on the Energy Storage Properties of Fine‐grained BaTiO3‐based Ceramics

Defect Dipoles Induced High‐energy Storage Density in Mn‐doped BST Ceramics Prepared by Spark Plasma Sintering

Properties and Microstructure of Ultrafine-Crystalline BaTiO3-based Energy Storage Ceramics

Dielectric Properties of Low-Temperature Sintered Ba<sub>0.6</sub>Sr<sub>0.4</sub>TiO<sub>3</sub> Ceramics by Addition of Bi<sub>2</sub>O<sub>3</sub>-CuO Mixed Oxides

Ultrahigh Energy Density and Efficiency of BaTiO3-based Ceramics Via Multiple Design Strategies

Dielectric Properties And Low-Temperature Sintering Of The Ba0.6sr0.4tio3 Ceramics With B2o3/Cuo Additions

Dielectric Properties and Low‐Temperature Sintering of the <scp><scp>Ba</scp></scp><sub>0.6</sub><scp><scp>Sr</scp></scp><sub>0.4</sub><scp><scp>TiO</scp></scp><sub>3</sub> Ceramics with <scp><scp>B</scp></scp><sub>2</sub><scp><scp>O</scp></scp><sub>3</sub>/<scp><scp>CuO</scp></scp> Additions

Effects of Grain Size and Temperature on the Energy Storage and Dielectric Tunability of Non-Reducible BaTiO3-based Ceramics

The Effect of B2o3-Li2co3 Addition on Sintering Behavior and Dielectric Properties of Ba0.6sr0.4tio3 Ceramics

Energy Storage Performance of Lead-Free Ba0.7Sr0.3TiO3 Ceramics with Doping Bi(Mg0.5Ti0.5)O3

Enhanced Energy Storage Properties of Barium Strontium Titanate Ceramics Prepared by Sol-Gel Method and Spark Plasma Sintering

Influence of Sintering Temperature on Energy Storage Properties of BaTiO3–(Sr1−1.5Bi ) TiO3 Ceramics

Enhanced energy storage properties of (Ba0.4Sr0.6)TiO3 ceramics with ultrahigh energy efficiency through doping of Bi0.2Sr0.7(Mg1/3Nb2/3)O3

Optimized energy storage performance in (Ba0.8Sr0.2)TiO3-based ceramics via Bi(Zn0.5Hf0.5)O3-doping

BaTiO3-based Ceramics with High Energy Storage Density

Improved energy storage performance of Ba0.4Sr0.6TiO3 by doping high polarization BiFeO3

Effect of Rare Earth Oxides on the Energy Storage Performance of Sr0.7Bi0.2TiO3 Ceramics