Abstract:A facile sol–gel–hydrothermal process was used to synthesize Scandium and Gadolinium co-doped BaTiO3 nanocrystals in this paper. Similar to the previous studies, a single-phase solid-solution structure is hard to achieve for BaTiO3 materials doped with rare-earth ions like Sc- and Gd- via solid-state method. Here, uniform Ba1−xTi1−xGdxScxO3 (0≤x≤0.04) nanoparticles (NPs) with single-phase solid-solution cubic structure and average particle size of 30–40nm were obtained and Ba1−xTi1−xGdxScxO3 pellets prepared from as-synthesized nanopowders can be sintered at a lower temperature of 1150°C. The internal structures, chemical constitution and morphology were characterized by FT-IR spectra, XRD, TEM, HRTEM, Raman spectra and SEM analysis. The results clearly demonstrated that Sc3+ and Gd3+ have entered into the BaTiO3 lattice and led to structural distortion in a short range and all samples were single-phase tetragonal structure at room temperature. Additionally, the dielectric temperature stability was enhanced with Sc3+ and Gd3+ as dopants, since the single-phase BaTiO3 ceramics exhibited broadened dielectric peaks, decline of Curie temperature as well as low dielectric loss below 0.02. Ceramics containing 3mol% Sc3+ and Gd3+ can exhibit the best dielectric behaviour of εr ~1700 and Tc=32°C in this work.

Synthesis and properties study of BaTi0.95Sc0.05O3-δ nanopowders and ceramics

Polymorphism and Dielectric Properties of Sc-doped BaTiO3 Nanopowders Synthesized by Sol–gel Method

Synthesis and Microstructure Characterization of Gd- and Sc- Codoped Batio3 Nanopowders Via Sol-Gel Method

Scandium and Gadolinium Co-Doped BaTiO3 Nanoparticles and Ceramics Prepared by Sol–gel–hydrothermal Method: Facile Synthesis, Structural Characterization and Enhancement of Electrical Properties

Synthesis, Structure, and Dielectric Properties of a Novel Perovskite-Based Nanopowders Via Sol–gel Method: (1–X)batio3–xdysco3

The Effect of B2o3-Li2co3 Addition on Sintering Behavior and Dielectric Properties of Ba0.6sr0.4tio3 Ceramics

Improved Energy Storage Performance of Ba0.4Sr0.6TiO3 Nanocrystalline Ceramics Prepared by Using Oxalate Co-Precipitation and Spark Plasma Sintering

Sol–gel Synthesis and Characterization of Ba(1−x)SrxTiO3 Ceramics

Dielectric Properties of BaTiO3 Based Ceramics Prepared from Nano-powders

Synthesis of BaTi2O5 Nanopowders by Sol–Gel Method and the Dielectric Properties of the Ceramics

Structure and Electrical Properties of BaTiO3 Prepared by Sol–gel Process

Preparation and Dielectric Properties of (ca0.61,nd0.26)tio3 Nanoparticles by a Sol–gel Method

Synthesis and performance of tetragonal Ca2+ doped BaTiO3 fine powders

Effects of Sintering Temperature and Bi2O3, Y2O3 and MgO Co-Doping on the Dielectric Properties of X8R BaTiO3-based Ceramics

Effect of A- or B-Site Sc Doping on Sintering Temperature, Crystal Structure, Microstructure, and Properties of BaZrxTi1−xO3 Ceramics

Low-temperature Synthesis and Characterization of Complex Perovskite (ca0.61, Nd0.26)TiO3–(Nd0.55, Li0.35)TiO3 Nanopowders and Ceramics by Sol–gel Method

Fabrication and sintering densification behavior of (Sr1-xPbx) TiO3 nano-powder

Hydrothermal synthesis of high-purity BaTiO3 powders: control of powder phase and size, sintering density, and dielectric properties

Effect of Sintering Temperature on Low Frequency Response Properties of Ba0.6Sr0.4TiO3 Ceramic

Preparation Process of BST Dielectric Ceramics

Synthesis, microstructure and dielectric properties of zirconium doped barium strontium titanate obtained by solvothermal method