Abstract:The Nb and Co doped barium titanate was synthesized by sol-gel auto-ignition synthesis process (abbreviated SAS) and compared with the doped powder of the same composition prepared by conventional ball milling process. The phase structure, morphology of the two as-obtained powders and correlative dielectric properties of sintered BaTiO3-based ceramics were measured. The XRD analysis demonstrated that the SAS powder was the Ba(M0.047Ti0.953)O3(M=Nb, Co) solid solution based on BaTiO3; it further suggested that Nb and Co cations could replace the Ti ions and reach reciprocal balance of acceptors and donors during the decomposition step of the organic fuel by igniting the dried gel. TEM observation showed that the Ba(M0.047Ti0.953)O3(M=Nb, Co) particles were spherical with the size ranged from 30 to 110nm. Furthermore, it was found that the value of the Curie temperature of both the doped powders was being lowered in comparison with pure BaTiO3 (Tc≈128°C ); and the dielectric constant at room temperature of the SAS powder was 5840, which was much higher than that of the conventional ball milling doped powder(3013). It was attributed to the maximum homogeneous distribution of dopants in Ba-Ti initial solution at atomic level via the SAS process.

Gelation and heat treatment of preparing BaNc-4TisO-4 with îAutocombustion methods

Gelation and heat treatment of preparing BaNd2Ti5O14 with autocombustion methods

Gelation and Heat Treatment of Preparing BaNd2Ti5O14with Autocombustion Methods

PREPARATION AND SINTERING PROPERTIES OF BaTi4O9 BY CITRIC ACID GEL METHOD

The Characterization and Preparation of Nano-Scale Fe Doping Tio2 by Sol-Gel Method (I) - the Crystallization and Thermal Decomposition Process of Fe Doping Tio2 Xerogel Powders Using Thermal Tg-Ir Spectrometry

Preparation and Heat Treatment of Titania Aerogels by Ambient Pressure Drying

Citric Acid Gel Method Synthesis, Characterization And Dielectric Properties Of Single-Phase Bati4o9

Ba 4 Ti 13 O 30 Nanocrystals Prepared by Hydrothermal Method

Process for Non-Agglomerated Nanometer-Sized Barium Titanate Powders by Sol-Gel Auto-Igniting Synthesis

Structure and Electrical Properties of BaTiO3 Prepared by Sol–gel Process

Preparation of BaBi4Ti4O15 powder by sol-gel process

Preparation of Ti Doped BaFe12O19 Ceramics by a Sol-Gel Process

Preparation and characterization of ZnO-B2O3-SO2 by sol-gel method

Effects of Heat-Treatment Temperature on Preparation of the Sol-Gel-Derived Ag/TiO2 Films

Investigation of heat treatment condition, ethylene glycol and deionized water effects on the phase structure of Ba0.6Sr0.4TiO3 nanoparticles produced by the sol-gel method

Synthesis and Characterization of BaCe0.8Y0.2O2.9 Nanopowder by Sol-Gel Auto-Ignited Method

Behaviors Of Crystallization And Nanograin Growth In Sbt By A Sol-Gel Process

Preparation of Ba2Ti9O20 by gel self-propagation process

The Preparation of BaTi4O9 by Sol-Gel Method

Preparation and Dielectric Properties of the Nb and Co Doped Barium Titanate by Sol-Gel Auto-Ignition Synthesis Process

Sol–gel combustion synthesis of BNBT powders