Abstract:Non-agglomerated nano-sized BaTiO3 powders were prepared by a 3 step decomposition of barium titanyl citric acid chelate derived from Ba(NO3)2-TiO(NO3)2-citric acid-NH4NO3 based complex compound system. The 1st step was the thermal treatment of chelate wet gel at 150°C for 40min to remove water and non-bridging hydroxyl groups and to form expanded gel intermediate. The 2nd step was the decomposition of the organic fuel by igniting expanded gel intermediate at 300°C. The 3rd step was the formation of the high purity BaTiO3 by calcining the decomposed powders at 700°C for 2 hours. The most expanded gel intermediate was found to be a decisive factor for the elimination of hard agglomerate. In addition, the initial oxidant/fuel molar ratio was shown to strongly influence the characteristics of the powders thus obtained. The optimum oxidant/fuel value was 3 for obtaining non-agglomerated pure BaTiO3 powders with a particle size of 50 nm. The agglomerate degree of BaTiO3 powders was determined by particle morphology and uniformity of the green compact microstructure observed by field emission scanning electron microscopy and scanning electron microscope.

Process for Non-Agglomerated Nanometer-Sized Barium Titanate Powders by Sol-Gel Auto-Igniting Synthesis

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

Room-Temperature Synthesis of BaTiO<sub>3</sub>Nanoparticles in Large Batches

Synthesis of Highly Dispersed Barium Titanate Nanoparticles by a Novel Solvothermal Method

Low-temperature combustion synthesis of nanometer tetragonal barium titanate powders

Preparation of A Monodispersed Suspension of Barium Titanate Nanoparticles and Electrophoretic Deposition of Thin Films

PREPARATION AND SINTERING PROPERTIES OF BaTi4O9 BY CITRIC ACID GEL METHOD

Low-temperature Combustion Synthesis and Characterization of Nanosized Tetragonal Barium Titanate Powders

Citric Acid Gel Method Synthesis, Characterization And Dielectric Properties Of Single-Phase Bati4o9

Preparation of Ba2Ti9O20 by gel self-propagation process

Synthesis of Nanocrystalline 0.94Bi<sub>0.5</sub>Na<sub>0.5</sub>TiO<sub>3</sub>-0.06BaTiO<sub>3</sub> Powder by a Citrate Method

Preparation of Monodisperse Nanocrystalline Barium Titanate

Sol–gel based synthesis of ultrafine tetragonal BaTiO 3

Comparison of Characteristics of BaTiO<sub>3</sub> Prepared by Different Process

Structure and Electrical Properties of BaTiO3 Prepared by Sol–gel Process

Synthesis and Characterization of BaCe0.8Y0.2O2.9 Nanopowder by Sol-Gel Auto-Ignited Method

Synthesis of BaTi2O5 Nanopowders by Sol–Gel Method and the Dielectric Properties of the Ceramics

The Effect of Processing Parameters on Low-Temperature Combustion Synthesis Barium Titanate Powders

Sol–gel combustion synthesis of BNBT powders

Synthesis of BaTio3 nanocrystals by stearic acid gel method

The Synthesis of Ultrafine Ba/Sr Titanate Powders