Abstract:Piezoelectric vibration energy harvesting has drawn much research interest over the last decade toward the goal of enabling self-sustained wireless sensor nodes. In order to make use of the harvested energy, interface circuits are needed to rectify and manage the energy. Among all active interface circuits, synchronized switch harvesting on inductor (SSHI) and synchronous electric charge extraction are widely employed due to their high energy efficiencies. However, the cold-startup issue still remains, since an interface circuit needs a stable dc supply and the whole system is completely out of charge at the beginning of implementations or after a certain period of time without input vibration excitation. In this paper, a new cold-startup SSHI interface circuit is presented, which dynamically increases the open-circuit voltage generated from the piezoelectric transducer in the cold state to start the system under much lower excitation levels. The proposed circuit is designed and fabricated in a 0.18-mu m CMOS process and experimentally validated together with a custom microelectromechanical system harvester, which is designed with split electrodes to work with the proposed power extraction circuit. The experiments were performed to start the system from the cold state under variable excitation levels. The results show that the proposed system lowers the required excitation level by at least 50% in order to perform a cold startup. This aids restarting of the energy harvesting system under low excitation levels each time it enters the cold state.

A 400mv Supply Voltage Self-Start Clock Generator for Energy Harvest System.

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

Start-up module for low voltage energy harvesting systems

A Cold-Startup SSHI Rectifier for Piezoelectric Energy Harvesters with Increased Open-Circuit Voltage

30–300mV input, ultra-low power, self-startup DC-DC boost converter for energy harvesting system

A Novel ZVS High Voltage Power Supply for Micro-Channel Plate Photomultiplier Tubes

Self-powered piezoelectric energy harvesting with ultra-low power consumption for low-amplitude ambient vibrations

360Nw Self-Calibrated Clock Generator Operating from &#x2212;50&#x00b0;c to 120&Amp;#x00b0;c

A fast and low power consumption crystal oscillator driving circuit design.

A Dickson Hybrid Boost Converter With On-Chip Cold-Start for Thermoelectric Energy Harvesting.

A Compact Dickson Hybrid Boost Converter with 5-Mv Input 90.5% Peak Efficiency and On-Chip Cold-Start for Thermoelectric Energy Harvesting

Ultra-Low Power Boost Converter with Constant On-Time-Based Mppt for Energy Harvesting Applications

A Thermoelectric Energy Harvesting System Assisted by A Piezoelectric Transducer Achieving 10-mV Cold-Startup and 82.7% Peak Efficiency

A High-Precision Ultra-Low-power Hysteretic Voltage Detector for Energy Harvesting System

A Battery-Less Crystal-Less 49.8µw Neural-Recording Chip Featuring Two-Tone RF Power Harvesting.

Integrated Cold-Start of a Boost Converter at 54mv Using a Two-Stage Capacitive Voltage Multiplier

A fully integrated 28nm CMOS dual source adaptive thermoelectric and RF energy harvesting circuit with 110mv startup voltage

A Low-Voltage Self-Starting Boost Converter Using MPPT with Pulse Multiplication for Energy Harvesting

A 0.5-V, 0.05-to-3.2ghz LC-Based Clock Generator for Substituting Ring Oscillators under Low-Voltage Condition

A New Transformer-Based Startup Scheme with Novel Voltage Monitors for Energy Harvesting

A Startup Scheme for Zero-Voltage-switching PV Inverter