Abstract:The high precision and low power consumption of the clock generator are critical in passive RFID transponders and passive IoT chips, but fluctuations in PVT can cause considerable degradation in the precision of the chip's internal clocks. This paper proposes a high-precision clock circuit with a single-shot calibration method to addresses this issue in a low-power clock solution. Based on the reference timespan in the preamble of the down-link RF envelope, a TDIF (Time-digital to current-frequency) calibration method was implemented with both a streamlined procedure and customized circuits. By computing the difference between the time counts and applying it to an ultra-low-power, current-starved oscillator, the current change ratio can be linearly controlled. Compared to the traditional integer frequency division scheme used by passive tags for a 160 k bits up-link data rate, the required frequency for the clock generator was reduced from 960 kHz to 320 kHz, the calibration error was reduced from ±10% to ±3% for ±25% frequency deviation, the calibration time was 133.3 μs for a single shot in this work, and the power consumption was 158 nW after the calibration was completed. This leads to an excellent power efficiency of 0.59 nW/kHz and meets the requirements of low power, low cost, and PVT robustness in the RF-powered passive IoT chips. By appropriately increasing the number of calibration digits and the duration, this calibration approach could also be used for other ultra-low-power passive IoT chips that require higher-precision clocking without the use of off-chip crystals.

360Nw Self-Calibrated Clock Generator Operating from &#x2212;50&#x00b0;c to 120&Amp;#x00b0;c

An ultra-low power passive UHF RFID transponder with self-calibrated clock generator

A 0.59 nW/kHz Clock Circuit with High-Precision Clock Calibration for Passive Internet of Things Chips

A Low Power Clock Generator with Self-Calibration for UHF RFID Tags in Intelligent Terrestrial Sensor Networks

A 800nw High-Accuracy Rc Oscillator with Resistor Calibration for Rfid

A Self-Calibration Technique for On-Chip Precise Clock Generator

Ultra-low-power clock generation circuit for EPC standard UHF RFID transponders

Broadband Linearity Enhancement Method for a 1.3 GHz-2.5 GHz Digitally-Assisted Oscillator in a 55-Nm CMOS Technology

An UHF RFID Transponder with Novel Clock Generator and Demodulator

A low power baseband processor with clock variance-tolerant for UHF RFID transponder

An Ultra-Low-Power Oscillator with Temperature and Process Compensation for Uhf Rfid Transponder

A Digital Baseband with Novel Clock Generator for UHF RFID Tag

Power Management And Clock Generator For A Novel Passive Uwb Tag

Ultra low power oscillator for UHF RFID transponder

Clock Regenerator and Backscatter Modulator for UHF RFID Application

Clock Generator and OOK Modulator for RFID Application

A Digital Intensive Clock Recovery Circuit for HF-Band Active RFID Tag

An ultra-low power passive UHF RFID tag with a CTS oscillator

A Low Voltage, Low Power RF/Analog Front-End Circuit for Passive UHF RFID Tags

Novel baseband processor for ultra-low-power passive UHF RFID transponder

A Subgigahertz UWB Transmitter With Wireless Clock Harvesting for RF-Powered Applications

360Nw Self-Calibrated Clock Generator Operating from &amp;#x2212;50&amp;#x00b0;c to 120&Amp;#x00b0;c