Abstract:The high precision and low power consumption of the clock generator are critical in passive RFID transponders and passive IoT chips, but fluctuations in PVT can cause considerable degradation in the precision of the chip's internal clocks. This paper proposes a high-precision clock circuit with a single-shot calibration method to addresses this issue in a low-power clock solution. Based on the reference timespan in the preamble of the down-link RF envelope, a TDIF (Time-digital to current-frequency) calibration method was implemented with both a streamlined procedure and customized circuits. By computing the difference between the time counts and applying it to an ultra-low-power, current-starved oscillator, the current change ratio can be linearly controlled. Compared to the traditional integer frequency division scheme used by passive tags for a 160 k bits up-link data rate, the required frequency for the clock generator was reduced from 960 kHz to 320 kHz, the calibration error was reduced from ±10% to ±3% for ±25% frequency deviation, the calibration time was 133.3 μs for a single shot in this work, and the power consumption was 158 nW after the calibration was completed. This leads to an excellent power efficiency of 0.59 nW/kHz and meets the requirements of low power, low cost, and PVT robustness in the RF-powered passive IoT chips. By appropriately increasing the number of calibration digits and the duration, this calibration approach could also be used for other ultra-low-power passive IoT chips that require higher-precision clocking without the use of off-chip crystals.

A Self-Calibration Technique for On-Chip Precise Clock Generator

Study and design of an on chip clock generator with high stability

A Calibration Technique Based on Frequency-Domain Characteristics for Pipelined ADCs

A novel high-accuracy clock stabilizer with 50% duty cycle

Reliability Enhancement Methods for Relaxation Oscillator with Delay Time Cancellation

2.5 Mw 2.73 GHz Non-Overlapping Multi-Phase Clock Generator with Duty-Cycle Correction in 0.13 Μm CMOS

A New Capacitance-to-Frequency Converter for On-Chip Capacitance Measurement and Calibration in CMOS Technology

Practical system for phase noise measurement of optoelectronic oscillators

A 0.59 nW/kHz Clock Circuit with High-Precision Clock Calibration for Passive Internet of Things Chips

A New On-chip Signal Generator for Charge-Based Capacitance Measurement Circuit

Broadband Linearity Enhancement Method for a 1.3 GHz-2.5 GHz Digitally-Assisted Oscillator in a 55-Nm CMOS Technology

Crystal-less Oscillator Calibration Using Serial Data As Frequency Reference

A 800nw High-Accuracy Rc Oscillator with Resistor Calibration for Rfid

360Nw Self-Calibrated Clock Generator Operating from &#x2212;50&#x00b0;c to 120&Amp;#x00b0;c

A Quadrature Clock Generator with Calibration for 22&#x223c;31.4 GS/s Real-Time Sampling System

A 0.0068 mm~2 Self-calibration Circuit for Phase Locked Loop

A 12-Ghz All-Digital Calibration-Free FMCW Signal Generator Based on a Retiming Fractional Frequency Divider

Fully on-chip clock jitter and skew measurement scheme via incoherent subsampling

A Digital Calibration Technique for an Ultra High-Speed Wide-Bandwidth Folding and Interpolating Analog-to-digital Converter in 0.18μm CMOS Technology

ProCal: A Low-Cost and Programmable Calibration Tool for IoT Devices

A Novel Calibration Technique Applying to an Adaptive-Bandwidth PLL