Abstract:The high precision and low power consumption of the clock generator are critical in passive RFID transponders and passive IoT chips, but fluctuations in PVT can cause considerable degradation in the precision of the chip's internal clocks. This paper proposes a high-precision clock circuit with a single-shot calibration method to addresses this issue in a low-power clock solution. Based on the reference timespan in the preamble of the down-link RF envelope, a TDIF (Time-digital to current-frequency) calibration method was implemented with both a streamlined procedure and customized circuits. By computing the difference between the time counts and applying it to an ultra-low-power, current-starved oscillator, the current change ratio can be linearly controlled. Compared to the traditional integer frequency division scheme used by passive tags for a 160 k bits up-link data rate, the required frequency for the clock generator was reduced from 960 kHz to 320 kHz, the calibration error was reduced from ±10% to ±3% for ±25% frequency deviation, the calibration time was 133.3 μs for a single shot in this work, and the power consumption was 158 nW after the calibration was completed. This leads to an excellent power efficiency of 0.59 nW/kHz and meets the requirements of low power, low cost, and PVT robustness in the RF-powered passive IoT chips. By appropriately increasing the number of calibration digits and the duration, this calibration approach could also be used for other ultra-low-power passive IoT chips that require higher-precision clocking without the use of off-chip crystals.

A 800nw High-Accuracy Rc Oscillator with Resistor Calibration for Rfid

A Novel Ultra Low Noise CMOS Voltage Reference Circuit with Digital Calibration Scheme

A 0.59 nW/kHz Clock Circuit with High-Precision Clock Calibration for Passive Internet of Things Chips

360Nw Self-Calibrated Clock Generator Operating from &#x2212;50&#x00b0;c to 120&Amp;#x00b0;c

Broadband Linearity Enhancement Method for a 1.3 GHz-2.5 GHz Digitally-Assisted Oscillator in a 55-Nm CMOS Technology

A Self-Calibration Technique for On-Chip Precise Clock Generator

A Bridged Contactless Measurement Technique for LC Tank Based Voltage-Controlled Oscillator.

An ultra-low power passive UHF RFID tag with a CTS oscillator

A LOW POWER, LOW PHASE NOISE FBAR OSCILLATOR

A Digital Baseband with Novel Clock Generator for UHF RFID Tag

A Low Voltage Low Power Oscillator Suitable for RFID Transponder

A Digital Intensive Clock Recovery Circuit for HF-Band Active RFID Tag

A Low-Power Passive UHF Tag With High-Precision Temperature Sensor for Human Body Application

Ultra low power oscillator for UHF RFID transponder

An ultra-low power passive UHF RFID transponder with self-calibrated clock generator

A Novel Method to Improve the Subcarrier Frequency Accuracy for UHF RFID Sensing System

A Low Voltage, Low Power RF/Analog Front-End Circuit for Passive UHF RFID Tags

Ultra-low-power clock generation circuit for EPC standard UHF RFID transponders

Crystal-less Oscillator Calibration Using Serial Data As Frequency Reference

A 92 Fsrms Jitter Frequency Synthesizer Based on a Multicore Class-C Voltage-Controlled Oscillator with Digital Automatic Amplitude Control

Clock Generator and OOK Modulator for RFID Application