Abstract:A UHF RFID Reader Transceiver for China standard (840 similar to 925 MHz) as well as meeting the protocols of EPC Class-1 Gen-2 and ISO/IEC 18000-6C is presented. To suppress the large self-jammer from transmitter to receiver, an on-chip self-jammer cancellation (SC) circuits and a fully-integrated DC-offset Cancellation (DCOC) circuits with quickly time-varying cut-off frequency are proposed to kill the self-jammer within 15 its. Furthermore, a mixer with capacitor cross-coupled (CCC) common-gate input stage and vertical NPN BJT switching stage is proposed to achieve high linearity (-8 dBm P1dB), good wideband matching and low 1/f noise corner. The transmitter integrated with a CMOS class-AB PA of 22 dBm output power in linear mode with 35% PAE, which is suitable for mobile applications, supports the DSB/SSB/PR-ASK modulation schemes and achieves ACPR1 of -45 dBc and ACPR2 of -60 dBc, which satisfies the stringent spectral mask of China local requirements. A sigma-delta PLL with a single LC VCO is also implemented for 250 kHz channel hopping and good phase noise (-126 dBc/Hz at 1MHz offset). The receiver has a sensitivity of down to -77 dBm in the presence of 20 dBm PA output power. The single-chip is implemented in standard 0.18 mu m CMOS process. It occupies 13.5 mm(2) silicon areas, and consumes 113 mA (without PA) from 1.8V supply voltage.

Clock Regenerator and Backscatter Modulator for UHF RFID Application

Clock Generator and OOK Modulator for RFID Application

An UHF RFID Transponder with Novel Clock Generator and Demodulator

A Digital Intensive Clock Recovery Circuit for HF-Band Active RFID Tag

A Digital Baseband with Novel Clock Generator for UHF RFID Tag

Design for the reader of UHF Radio frequency identification

A System Design for the Reader of Microwave Radio Frequency Identification

Simulation Study for the Decoding of UHF RFID Signals

A Novel RFID Architecture Supporting Accurate Clock Transfer for Backscatter Communication

Design of a Modulator and Demodulator for UHF RFID Readers

Design of Digital Receiver for UHF RFID Reader

Low Power Design of UHF RFID Tag Baseband Processor

A low power baseband processor with clock variance-tolerant for UHF RFID transponder

An Ultra Low Power Digital Processor for Chinese UHF RFID Transponder

360Nw Self-Calibrated Clock Generator Operating from &#x2212;50&#x00b0;c to 120&Amp;#x00b0;c

Design of Several Key Circuits of UHF Passive RFID Tag

A Miniaturized Multi-protocol UHF RFID Reader Module

Design and realization of UHF RFID reader digital baseband

Power Management And Clock Generator For A Novel Passive Uwb Tag

An ultra-low power passive UHF RFID transponder with self-calibrated clock generator

A Single-Chip Cmos Uhf Rfid Reader Transceiver For Mobile Applications