Abstract:This article describes a much simplified, Digital and analog mixed architecture that support general S-band transponder operation. The mass is reduced to under 1.4kg (including TCXO), and the dimension is about 170 *70*100mm. The power consumption is less than 11W measured in the side of 28V input with 1W SSPA transmitter output. The mass cut down is benefit mainly from the progress of digital design techniques and the improvement of the FPGA technologies. The designer implements the IF command and tracking demodulation by a 3 million system gates FPGA. Furthermore, the device is employed with tri-mode-redundancy. The algorithm of the main carrier tracking is based on phase lock loop, the command demodulation is based on Costas loop for sub carrier tracking and DTTL loop for bit synchronization. The carrier acquisition threshold is under -128 dBm with PM/BPSK demodulation losses < 1dB. The dynamic range is from -128 dBm to -55 dBm. The second technique that decreases the complexity is the structure of RF front-side. We use a small size saturated amplifier replacing the AGC amplifier, the saturation amplifier depresses the mostly of the signal dynamic and DSP deal with the dynamic left. We select a low power A/D converter with working frequency under 3Msps in under-sampling mode; however, the IF frequency is about 9.3MHz that can diminish the order of RF front-side down converter and the difficulties of analog band pass filter design. For the standard of the USB transmitter is only support modulation type: BPSK/PM, so we build a RF-IF close loop transmitter architecture that eliminate the components used in up converter architecture, the saved mixers and band pass filters extremely reduce the amount and the volume of PCB. Moreover, we creatively put the coherent forwarding signal generator and the Frequency-Phase Detector together in FPGA. The digital phase noise or jitter is wonderfully filtered by a well-designed analog low pass loop filter. To conclude, there is not any DAC or RF-filter in transponder's transmitter loop. The other advantage is that we can adjust the modulation index easily by digital parameter. The transponder developed by NSSC is under flight verification.

A Novel RFID Architecture Supporting Accurate Clock Transfer for Backscatter Communication

An UHF RFID Transponder with Novel Clock Generator and Demodulator

High Data Capacity Chipless RFID Tag Based on Time Domain Scattering Modulation

Clock Regenerator and Backscatter Modulator for UHF RFID Application

A Digital Intensive Clock Recovery Circuit for HF-Band Active RFID Tag

A Digital Baseband with Novel Clock Generator for UHF RFID Tag

A System Design for the Reader of Microwave Radio Frequency Identification

An All Digital Packet DS-CDMA Transceiver for HFC Network Upstream Transmission

A novel RFID transceiver architecture with enhanced readability

Design for the reader of UHF Radio frequency identification

A Low-Power Dual-Clock Strategy for Digital Circuits of Epc Gen2 Rfid Tag

A Novel Compact Low-Power Direct Conversion Receiver for Mobile UHF RFID Reader

A New Architecture of UHF RFID Digital Receiver for SoC Implementation

A creative architecture for mass-sensitive transponder

HD-Scatter: Improving the Hardware Design of Advanced Backscatter System

A digital IF based UHF RFID reader transmitter

A Novel Cmos Transmitter Front-End For Mobile Rfid Reader

Power Management And Clock Generator For A Novel Passive Uwb Tag

A Novel Dual Passive Mixer-first Receiver Front-End with Enhanced RF Carrier Leakage Suppression for UHF RFID Reader

Analysis of Clock Strategy and Protocol Conformance for Digital Circuits in EPC Gen2 RFID Tag

A Novel Baseband-Processor for LF RFID Tag