Abstract:RFID tags have gradually become popular tools for identification of products. To ensure the secure information transaction of tags, a scheme of RFID system authentication protocol based on Elliptic Curve Cryptography (ECC) is proposed. However, hardware implementation of ECC processor for RFID tags is a challenge for the requirements of low-power consumption and low-cost chip resource. In the paper we propose a novel ALU architecture for ECC processor on tags. By specially restructured the conventional mathematical expressions of Montgomery algorithm, the ALU operation of point multiplication in our design is reduced by nearly 47%. Also, various multipliers, such as bit-serial multiplier, digit-serial multiplier and the divided algorithm are adopted to balance between power consumption and speed. To attain ultra low power consumption, other techniques, such as finite state machines (FSM) optimization, clock gating, pipelining operations and low-power target library are used in the design. The area of the ECC processor is equal to 16.9k gates equivalents. It performs an elliptic curve point multiplication in 36174 clock cycles and has a power consumption of 6.607 mu W at 1.28 MHz using TSMC 0.18 mu m low-voltage cell library.

A Low-Power Dual-Clock Strategy for Digital Circuits of Epc Gen2 Rfid Tag

Analysis of Clock Strategy and Protocol Conformance for Digital Circuits in EPC Gen2 RFID Tag

A Clock Isolation Technique for Low Power SoC Design

Low Power Design of UHF RFID Tag Baseband Processor

Design of a low-cost low-power baseband-processor for UHF RFID tag with asynchronous design technique

A Digital Baseband with Novel Clock Generator for UHF RFID Tag

Power Management And Clock Generator For A Novel Passive Uwb Tag

Ultralow-voltage, low-power baseband processor for UHF RFID tags

A Clock Calibration Method for EPC Gen2 Tags

Low-power Hardware Implementation of ECC Processor Suitable for Low-Cost RFID Tags

Ultra-low-power clock generation circuit for EPC standard UHF RFID transponders

A Digital Intensive Clock Recovery Circuit for HF-Band Active RFID Tag

An Ultra Low-Voltage, Low-Power Baseband-Processor for UHF RFID Tag

Design of a Novel Digital Baseband for UHF RFID Tag

An ultra-low power passive UHF RFID transponder with self-calibrated clock generator

Research on Low-Power Digital Integrated Circuit Technology

Optimize the Power Consumption of Passive Electronic Tags for Anti-Collision Schemes

An ultra-low power passive UHF RFID tag with a CTS oscillator

An Asynchronous Design Method and Its Application on a Low-Power RFID Baseband Processor

An Ultra Low Power Digital Processor for Chinese UHF RFID Transponder

ASIC Implementation of Low Power Baseband Processor for UHF RFID Tag