Abstract:A 61-MHz Pierce oscillator constructed in 0.35-<inline-formula> <tex-math notation="LaTeX">$\mu \text{m}$ </tex-math></inline-formula> CMOS technology and referenced to a polysilicon surface-micromachined capacitive-gap-transduced wine-glass disk resonator has achieved phase noise marks of −119 dBc/Hz at 1-kHz offset and −139 dBc/Hz at far-from-carrier offsets. When divided down to 13 MHz, this corresponds to −132 dBc/Hz at 1-kHz offset from the carrier and −152 dBc/Hz far-from-carrier, sufficient for mobile phone reference oscillator applications, using a single MEMS resonator, i.e., without the need to array multiple resonators. Key to achieving these marks is a Pierce-based circuit design that harnesses a MEMS-enabled input-to-output shunt capacitance more than <inline-formula> <tex-math notation="LaTeX">$100\times $ </tex-math></inline-formula> smaller than exhibited by macroscopic quartz crystals to enable enough negative resistance to instigate and sustain oscillation while consuming only <inline-formula> <tex-math notation="LaTeX">$78~\mu \text{W}$ </tex-math></inline-formula> of power—a reduction of <inline-formula> <tex-math notation="LaTeX">$\sim 4.5\times $ </tex-math></inline-formula> over previous work. Increasing the bias voltage of the resonator by 1.25 V further reduces power consumption to <inline-formula> <tex-math notation="LaTeX">$43~\mu \text{W}$ </tex-math></inline-formula> at the cost of only a few decibels in far-from-carrier phase noise. This oscillator achieves a 1-kHz-offset figure of merit (FOM) of −231 dB, which is now the best among published chip-scale oscillators to date. A complete linear circuit analysis quantifies the influence of resonator input-to-output shunt capacitance on power consumption and predicts further reductions in power consumption via reduction of electrode-to-resonator transducer gaps and bond pad sizes. The demonstrated phase noise and power consumption posted by this tiny MEMS-based oscillator are attractive as potential enablers for low-power “set-and-forget” autonomous sensor networks and embedded radios.

A fast and low power consumption crystal oscillator driving circuit design.

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

Low-dropout regulator with no off-chip capacitor and ultra low power consumption

2.5 Mw 2.73 GHz Non-Overlapping Multi-Phase Clock Generator with Duty-Cycle Correction in 0.13 Μm CMOS

1 V 10 GHz CMOS frequency divider with low power consumption

Design of A 1.8 V Low Power 2 GHz Prescaler

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

Analysis And Design Of Quickly Starting Crystal Oscillator

3.8 A 0.954nw 32khz Crystal Oscillator in 22nm CMOS with Gm-C-Based Current Injection Control

Design of Low Power Cmos Crystal Oscillator with Tuning Capacitors

Design of a Crystal Oscillator Chip with High Stability and Wide Power Supply Range

Low-Power MEMS-Based Pierce Oscillator Using a 61-MHz Capacitive-Gap Disk Resonator

A Reference-Free Capacitive-Discharging Oscillator Architecture Consuming 44.4 pW/75.6 nW at 2.8 Hz/6.4 kHz

A 0.7-V Clock-gating Cell with Power Gating Technology and 1.56-pA Sleep Power

Suppression of overtone oscillation and low‐current operation using novel‐design scheme for quartz crystal oscillators

A -193.1Dbc/hz FOM 1.08mw Low Power 10ghz VCO in 22nm CMOS Technology

A low-power 10Gb/s CMOS clock and data recovery circuit with a quarter-rate phase detector

A 0.35–0.5-V 18–152 MHz Digitally Controlled Relaxation Oscillator with Adaptive Threshold Calibration in 65-Nm CMOS

A 51-nW 32.7-kHz CMOS relaxation oscillator with half-period pre-charge compensation scheme for ultra-low power systems

A 32-ppm/degrees C 0.9-nW/kHz Relaxation Oscillator with Event-Driven Architecture and Charge Reuse Technique