Abstract:Ultra-low-power (ULP) crystal oscillators (X0s) [1–5] are essential in wirelessly linked loT nodes: for time-keeping purposes, they need to consume low power since they stay always-on and remain accurate to reduce synchronization guard time [6]. In recent years, pulse-injection-based X0s (PIX0s) have gained attention for their nW-level low power with good frequency stability. Typically implemented with a classic pierce oscillator for startup, these designs aim to take over the established parallel oscillation and replenish only the energy loss in the crystal by injecting short current pulses at the oscillating nodes' voltage peaks and valleys. They promise lower power consumption since they don't rely on a small-signal negative resistance that requires a high static bias current, seen as the crossbar current in the inverter. Yet to design these PIX0s, the designers must face two challenges, as shown in Fig. 3.8.1. The first is the timing control for the injected current pulses. Setting the rising zero-crossing point of the oscillating waveform as the $0^\circ$ phase reference (or 0 in time), this scheme requires a positive current push at $90^{\circ}$ (or T/4) and a negative current pull at $270^{\circ}$ (or 3T/4). Misalignments in timing create an orthogonal current component disrupting the phase, translating noise in the circuit to jitter while reducing the energy efficiency to maintain the same oscillation amplitude. The second challenge is oscillation amplitude control. For ultra-low-power operation, the oscillation amplitude needs to be low but stable since a linear increase in the oscillation amplitude leads to quadratic power consumption to compensate for the loss in the crystal.

Design of Low Power Cmos Crystal Oscillator with Tuning Capacitors

A Low- Power CMOS Ring- Based Oscillator Using Current Steering Logic Structure

Reliability Enhancement Methods for Relaxation Oscillator with Delay Time Cancellation

Design of a Crystal Oscillator Chip with High Stability and Wide Power Supply Range

A Low Power Low Supply Sensitivity Current-Mode Relaxation Oscillator

A CMOS Relaxation Oscillator with Process and Temperature Variation Compensation.

LC voltage-controlled oscillator tuned by switched step capacitors: Part II. Circuit design and implementation

Design of Area-Efficient GHz Range Current Mode Frequency Synthesizer Using Standard CMOS Technology

A Tuning Range Extension Technique for Waveform-Shaping Single-Core CMOS Oscillators with No Dedicated Harmonic Tuning

Design of a Crystal Oscillator Circuit

A fast and low power consumption crystal oscillator driving circuit design.

Promising 5.0-16.0 Ghz Cmos-Based Oscillatorswith Tuned Lc Tank

Analysis and Design of 32.768khz Crystal Oscillator for RTC

A 43 nW, 32 kHz, ±4.2 ppm Piecewise Linear Temperature-Compensated Crystal Oscillator With ΔΣ-Modulated Load Capacitance

Suppression of overtone oscillation and low‐current operation using novel‐design scheme for quartz crystal oscillators

The Design of a 2.82～4.04 GHz CMOS Differential Tuned LC VCO

The Circuit Design of a Voltage-controlled Crystal Oscillator

Analysis and Design of a CMOS Current-Controlled Oscillator

A design of low power multi-GHz LC VCO

3.8 A 0.954nw 32khz Crystal Oscillator in 22nm CMOS with Gm-C-Based Current Injection Control

A 23-30.8 GHz Digital-Controlled-Oscillator in 28nm CMOS