Abstract:This brief presents a low phase noise class-C voltage-controlled oscillator with bond wire inductors. To improve the Q-factor of inductors, the voltage-controlled oscillator employs bond wires as the inductors of the resonators. A transient-analysis-compatible equivalent circuit is proposed to precisely estimate the influence of mutual inductance, parasitic components and silicon substrate. Possible phenomena of oscillation mode ambiguity and oscillation failure are analyzed to be relative with the magnetic coupling between bond wires. An equation is derived to set up the relation among oscillation mode, bond wire coupling and frequency ratio of adjacent oscillators. And a costless placement reorder method is proposed to prevent the oscillator cores from oscillating failure and mode ambiguity. The voltage-controlled oscillator is implemented in a 65-nm CMOS process. Ten groups of gold double bond wires with a 20 $\mu \text{m}$ diameter, 70 $\mu \text{m}$ height and 800 $\mu \text{m}$ horizontal length are adopted as the inductors. The total tuning range of the oscillator is from 2.22 GHz to 4.46 GHz. When oscillating at 4.46 GHz and the output frequency divide ratio is 2, the output signal provides phase noise performance of −137.3 dBc/Hz at 1 MHz offset from 2.23 GHz. The maximum power consumption is 38 mW and each oscillator core occupies a chip area of only 0.112 mm 2 .

Design of a Crystal Oscillator Circuit

New Oscillator-Based Random Source Circuit and Fast Simulation

Design of a Crystal Oscillator Chip with High Stability and Wide Power Supply Range

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

Modeling, Optimization and Control of Rotary Traveling-Wave Oscillator

Analysis And Design Of Quickly Starting Crystal Oscillator

Design of Low Power Cmos Crystal Oscillator with Tuning Capacitors

Design of digitally-controlled crystal oscillator for GSM/EDGE radio-frequency integrated chip

An accurate ISF-based analysis and simulation method for phase noise in LC/Ring oscillators

Frequency Stabilization of an Optoelectronic Oscillator Based on Phase-Locked-Loop

Prediction, simulation, and verification of the phase noise in 80-MHz low-phase-noise crystal oscillators

A 0.07-Ppm/step Differential Digitally Controlled Crystal Oscillator with Guaranteed Monotonicity

Design of Voltage-Controlled Oscillator in GSM/EDGE Handset RFIC

A Comprehensive Model for Phase Noise Characteristics of an Optoelectronic Oscillator

A Low-Phase-noise Digitally Controlled Crystal Oscillator for DVB TV Tuners

Temperature compensated crystal oscillator design in Keysight ADS

Case Study of Interconnect Analysis for Standing Wave Oscillator Design

Design of chip-level clock system using frequency tunable standing-wave oscillators

Suppression of overtone oscillation and low‐current operation using novel‐design scheme for quartz crystal oscillators

Improvement of Frequency Source Phase Noise Reduction Design under Vibration Condition

Analysis and Design of a High-Frequency RC Oscillator Suitable for Mass Production