Abstract:Abstract The data acquisition system is widely used in electronic measuring instruments, for example, the oscilloscope . The development direction of the oscilloscope reflects the research status and development trend of the data acquisition system. Currently, the index of oscilloscopes is progressing toward a high sampling rate, and the performance of the analog‐to‐digital converter (ADC) has become the main bottleneck to improve the sampling rate of the acquisition system. The alternate sampling technology entails multichannel low sampling rate ADCs to achieve high sampling rate data acquisition through parallel sampling and realize data reconstruction through software. The sampling clock is the most important and difficult part of the system. For ADCs with the 100‐GS/s sampling rate and 10‐bit resolution, the jitter of the sampling clock needs to be in sub‐100 fs along with multiple phases. Based on the principle of injection locking, a 150‐GS/s sampling clock is proposed in this paper, which is implemented in a 0.15‐μm GaAs process, and the 50‐GHz locking range is achieved. The measurement results show that the sampling frequency is 150 GS/s, the root mean square (RMS) jitter is 63 fs with the integrated range from 1 kHz to 10 MHz, and the phase noise can meet the sampling requirements of the 10‐bit oscilloscope, which can provide a clocking scheme for small and low‐power ultrahigh‐speed oscilloscope.

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

Design of monolithic Phase-Locked Loop circuit for high-speed serial data link

A Multiphase Clock Generation Based On Dll For Source Synchronous Receiver In 65nm Cmos Technology

A Dll Based Low-Phase-Noise Clock Multiplier with Offset-Tolerant Pfd

2.5 Mw 2.73 GHz Non-Overlapping Multi-Phase Clock Generator with Duty-Cycle Correction in 0.13 Μm CMOS

A 2.4 mW 2.5 GHz multi-phase clock generator with duty cycle imbalance correction in 0.13 µm CMOS

Multi-chip Phase Synchronization Circuit of Fractional-N PLL

A Clock Interpolation Structure Using DLL for Clock Distribution in ADC.

A Multiphase Clock Generation for U WB Transceiver

Design Of Low-Jitter 1-Ghz Phase-Locked Loops For Digital Clock Generation

A Programmable Dco-Based Digital Clock Multiplier and Divider

Low-Jitter Multi-Phase Clock Generation: A Comparison Between Dlls And Shift Registers

A Spread-Spectrum Clock Generator with FIR-embedded Binary Phase Detection and 1-Bit High-Order ΔΣ Modulation.

An evenly-spaced-phase all-digital DLL using dual-loop SAR control

A 10‐MHz to 50‐GHz low‐jitter multiphase clock generator for high‐speed oscilloscope in 0.15‐μm GaAs technology

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A Programmable DCO-based Fast-Locking Clock Generator

A 500 kHz to 150 MHz Multi-Output Clock Generator Using Analog PLL and Open-Loop Fractional Divider with 0.13 μm CMOS

A shared TDC-based fast-lock all-digital DLL using a DCC-embedded delay line

A Novel Digital DLL and Its Implement on the FPGA.

A PLL/DLL Based CDR with ΔΣ Frequency Tracking and Low Algorithmic Jitter Generation