Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A PLL/DLL Based CDR with ΔΣ Frequency Tracking and Low Algorithmic Jitter Generation

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

Delay‐locked Loop Based Clock and Data Recovery with Wide Operating Range and Low Jitter in a 65‐nm CMOS Process

A 781mbps-5gbps Dll-Based Cdr With Starting-Control Circuit

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

10.709 Gbit/s CDR Based on Phase Locked Loop

A 2.5GHz ADPLL with PVT-insensitive ΔΣ dithered time-to-digital conversion by utilizing an ADDLL.

A 32-Gb/s 0.46-pJ/bit PAM4 CDR Using a Quarter-Rate Linear Phase Detector and a Self-Biased PLL-Based Multiphase Clock Generator

A 0.022mm2 970µw Dual-Loop Injection-Locked PLL with −243db FOM Using Synthesizable All-Digital PVT Calibration Circuits

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 0.4-Ps-jitter −52-Dbc-spur Synthesizable Injection-Locked PLL with Self-Clocked Nonoverlap Update and Slope-Balanced Subsampling BBPD

A Dll Based Low-Phase-Noise Clock Multiplier with Offset-Tolerant Pfd

An evenly-spaced-phase all-digital DLL using dual-loop SAR control

A 10 GHz 56 Fsrms-Integrated-jitter and −247 Db FOM Ring-Vco Based Injection-Locked Clock Multiplier with a Continuous Frequency-Tracking Loop in 65 Nm CMOS

A 5.4 GHZ All-Digital Phase-Locked Loop with a wide output swing and high-linearity DAC

A Phase Locked Loop for Clock Recove Ry Circuit Using Low-Jitter Variable Delay Line

A Fractional- N DTC-based ADPLL using path-select multi-delay line TDC and true fractional division technique

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A PLL/DLL Based CDR with &#x0394;&#x03a3; Frequency Tracking and Low Algorithmic Jitter Generation