Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A 32-Gb/s 0.46-pJ/bit PAM4 CDR Using a Quarter-Rate Linear Phase Detector and a Self-Biased PLL-Based Multiphase Clock Generator

A 5/10 Gb/s Dual-Mode NRZ/PAM4 CDR in 65-Nm CMOS

A Sub-0.25-pJ/bit 47.6-to-58.8-Gb/s Reference-Less FD-Less Single-Loop PAM-4 Bang-Bang CDR With a Deliberate-Current-Mismatch Frequency Acquisition Technique in 28-nm CMOS

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A 60-Gb/s 1.2-pJ/bit 1/4-Rate PAM-4 Receiver With a Jitter Compensation CDR

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

A 40 Gb/s 74.9 mW PAM4 receiver with novel clock and data recovery

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 112-Gb/s PAM-4 Receiver with Ultra-Fine GainAdjustment CTLE and Novel Sample-and-Reset Slicer in 28-Nm CMOS

A 0.14-to-0.29-pJ/bit 14-GBaud/s Trimodal (NRZ/PAM-4/PAM-8) Half-Rate Bang-Bang Clock and Data Recovery (BBCDR) Circuit in 28-nm CMOS

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

A 1/4-RATE LINEAR PHASE DETECTOR FOR HIGH SPEED PLL-BASED CLOCK AND DATA RECOVERY CIRCUIT

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A Half Rate CDR with DCD Cleaning Up and Quadrature Clock Calibration for 20gbps 60ghz Communication in 65nm CMOS.

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 51gb/s, 320mw, PAM4 CDR with Baud-Rate Sampling for High-Speed Optical Interconnects

A 1.41-Pj/b 56-Gb/s PAM-4 Receiver Using Enhanced Transition Utilization CDR and Genetic Adaptation Algorithms in 7-Nm CMOS

A 1.25/2.5/3.125Gbps CDR circuit with a phase interpolator for RapidIO application