Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A 1/4-RATE LINEAR PHASE DETECTOR FOR HIGH SPEED PLL-BASED CLOCK AND DATA RECOVERY CIRCUIT

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

Design of monolithic Phase-Locked Loop circuit for high-speed serial data link

A low-power 10Gb/s CMOS clock and data recovery circuit with a quarter-rate phase detector

A 32-Gb/s 0.46-pJ/bit PAM4 CDR Using a Quarter-Rate Linear Phase Detector and a Self-Biased PLL-Based Multiphase Clock Generator

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 1.25/2.5/3.125Gbps CDR circuit with a phase interpolator for RapidIO application

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

An improved Phase/Frequency Detector and a glitch-suppression charge pump design for PLL applications

A New Architecture High Speed Clock and Data Recovery Circuit

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A Low-Power and High-Frequency Phase Frequency Detector for a 3.33-GHz Delay Locked Loop

Theoretical Modeling and Simulation of Phase-Locked Loop (PLL) for Clock Data Recovery (CDR)

A Power Scalable 2-10 Gb/s PI-based Clock Data Recovery for Multilane Applications.

A PLL/DLL Based CDR with ΔΣ Frequency Tracking and Low Algorithmic Jitter Generation

Delay‐locked Loop Based Clock and Data Recovery with Wide Operating Range and Low Jitter in a 65‐nm CMOS Process

A speculative clock and data recovery architecture for multi-gigabit/s series links