Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A Power Scalable 2-10 Gb/s PI-based Clock Data Recovery for Multilane Applications.

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

A 3.125gbit/s CMOS Clock and Data Recovery Circuit

A 1.25/2.5/3.125Gbps CDR circuit with a phase interpolator for RapidIO application

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

Clock and Data Recovery for 10-Gb/s EPON Application

A speculative clock and data recovery architecture for multi-gigabit/s series links

A 5 Gb/s Low Area CDR for Embedded Clock Serial Links

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

An improved 40 Gb/s CDR with jitter-suppression filters and phase-compensating interpolators