Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A 3.125gbit/s CMOS Clock and Data Recovery Circuit

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A New Architecture High Speed Clock and Data Recovery Circuit

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A 0.32–2.7 Gb/s Reference-Less Continuous-Rate Clock and Data Recovery Circuit With Unrestricted and Fast Frequency Acquisition

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

A 5 Gb/s Low Area CDR for Embedded Clock Serial Links

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

Delay‐locked Loop Based Clock and Data Recovery with Wide Operating Range and Low Jitter in a 65‐nm CMOS Process

A Power Scalable 2-10 Gb/s PI-based Clock Data Recovery for Multilane Applications.

A 1-Gbps reference-less burst-mode CDR with embedded TDC in a 65-nm CMOS process.

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

Clock and Data Recovery for 10-Gb/s EPON Application

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector