Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

Delay‐locked Loop Based Clock and Data Recovery with Wide Operating Range and Low Jitter in a 65‐nm CMOS Process

A 3.125gbit/s CMOS Clock and Data Recovery Circuit

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

A Power Scalable 2-10 Gb/s PI-based Clock Data Recovery for Multilane Applications.

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

A 781mbps-5gbps Dll-Based Cdr With Starting-Control Circuit

A 5 Gb/s Low Area CDR for Embedded Clock Serial Links

A 10gbps Half-Rate Digital Clock And Data Recovery Circuit For 60ghz Receiver In 65nm Cmos

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

A 0.32–2.7 Gb/s Reference-Less Continuous-Rate Clock and Data Recovery Circuit With Unrestricted and Fast Frequency Acquisition

A 12.5-mb/s to 2.7-Gb/s continuous-rate CDR with automatic frequency acquisition and data-rate readback

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

Clock and Data Recovery for 10-Gb/s EPON Application