Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

An improved 40 Gb/s CDR with jitter-suppression filters and phase-compensating interpolators

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A Power Scalable 2-10 Gb/s PI-based Clock Data Recovery for Multilane Applications.

A 5 Gb/s Low Area CDR for Embedded Clock Serial Links

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A 10Gbps CDR based on phase interpolator for source synchronous receiver in 65nm CMOS

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

A statistical jitter tolerance estimation applied for clock and data recovery using oversampling

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

A 32-Gb/s 0.46-pJ/bit PAM4 CDR Using a Quarter-Rate Linear Phase Detector and a Self-Biased PLL-Based Multiphase Clock Generator

A 1-Gbps reference-less burst-mode CDR with embedded TDC in a 65-nm CMOS process.

A 1.25/2.5/3.125Gbps CDR circuit with a phase interpolator for RapidIO application

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

A Low-Jitter Full-Rate 25-Gb/s CDR for 100-Gb/s Optical Interconnects in 0.13-μm SiGe BiCMOS

A 0.2–7.1-Gb/s Low-Jitter Full-Rate Reference-Less CDR for Communication Signal Analyzers

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 781mbps-5gbps Dll-Based Cdr With Starting-Control Circuit