Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A Low-Jitter Full-Rate 25-Gb/s CDR for 100-Gb/s Optical Interconnects in 0.13-μm SiGe BiCMOS

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

A 1.2 Gbps Failsafe Low Jitter LVDS Transmitter-Receiver Applied in CMOS Image Sensor.

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A Fully-Synthesizable 10.06gbps 16.1mw Injection-Locked CDR in 28nm FDSOI.

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A 10Gbps CDR based on phase interpolator for source synchronous receiver in 65nm CMOS

A 1-Gbps reference-less burst-mode CDR with embedded TDC in a 65-nm CMOS process.

A 1.25/2.5/3.125Gbps CDR circuit with a phase interpolator for RapidIO application

A 3.125gbit/s CMOS Clock and Data Recovery Circuit

A 0.2–7.1-Gb/s Low-Jitter Full-Rate Reference-Less CDR for Communication Signal Analyzers

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

A 50gb/s CMOS Optical Receiver with Si-Photonics PD for High-Speed Low-Latency Chiplet I/O.

A CMOS 3.125 Gb/s Receiver for Multichannel 10 Gbit Ethernet Interface

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A Half Rate CDR with DCD Cleaning Up and Quadrature Clock Calibration for 20gbps 60ghz Communication in 65nm CMOS.

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition