Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A Fully-Synthesizable 10.06gbps 16.1mw Injection-Locked CDR in 28nm FDSOI.

A 0.011 mm2 PVT-robust fully-synthesizable CDR with a data rate of 10.05 Gb/s in 28nm FD SOI

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

A 1-Gbps reference-less burst-mode CDR with embedded TDC in a 65-nm CMOS process.

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A Low-Jitter Full-Rate 25-Gb/s CDR for 100-Gb/s Optical Interconnects in 0.13-μm SiGe BiCMOS

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

A 4–20-Gb/s 1.87-pJ/b Continuous-Rate Digital CDR Circuit With Unlimited Frequency Acquisition Capability in 65-nm CMOS

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

A 12.5-mb/s to 2.7-Gb/s continuous-rate CDR with automatic frequency acquisition and data-rate readback

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A 1.25/2.5/3.125Gbps CDR circuit with a phase interpolator for RapidIO application

A Reference-Less All-Digital Burst-Mode CDR with Embedded TDC.

A 10Gbps CDR based on phase interpolator for source synchronous receiver in 65nm CMOS

A Clock and Data Recovery Circuit for 3.125gb/s RapidIO SerDes

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 4x32Gb/s 1.8pJ/bit Collaborative Baud-Rate CDR with Background Eye-Climbing Algorithm and Low-Power Global Clock Distribution