Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A Sub-0.25-pJ/bit 47.6-to-58.8-Gb/s Reference-Less FD-Less Single-Loop PAM-4 Bang-Bang CDR With a Deliberate-Current-Mismatch Frequency Acquisition Technique in 28-nm CMOS

A 0.14-to-0.29-pJ/bit 14-GBaud/s Trimodal (NRZ/PAM-4/PAM-8) Half-Rate Bang-Bang Clock and Data Recovery (BBCDR) Circuit in 28-nm CMOS

A 6‐to‐38Gb/s capture‐range bang‐bang clock and data recovery circuit with deliberate‐current‐mismatch frequency detection and interpolation‐based multiphase clock generation

A 32-Gb/s 0.46-pJ/bit PAM4 CDR Using a Quarter-Rate Linear Phase Detector and a Self-Biased PLL-Based Multiphase Clock Generator

A 4–20-Gb/s 1.87-pJ/b Continuous-Rate Digital CDR Circuit With Unlimited Frequency Acquisition Capability in 65-nm CMOS

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

A 112-Gb/s PAM-4 Receiver with Ultra-Fine GainAdjustment CTLE and Novel Sample-and-Reset Slicer in 28-Nm CMOS

A 40 Gb/s 74.9 mW PAM4 receiver with novel clock and data recovery

A 5/10 Gb/s Dual-Mode NRZ/PAM4 CDR in 65-Nm CMOS

A 1.41-Pj/b 56-Gb/s PAM-4 Receiver Using Enhanced Transition Utilization CDR and Genetic Adaptation Algorithms in 7-Nm CMOS

A 0.32–2.7 Gb/s Reference-Less Continuous-Rate Clock and Data Recovery Circuit With Unrestricted and Fast Frequency Acquisition

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A 12.5-mb/s to 2.7-Gb/s continuous-rate CDR with automatic frequency acquisition and data-rate readback

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 60-Gb/s 1.2-pJ/bit 1/4-Rate PAM-4 Receiver With a Jitter Compensation CDR

A 28gbps Reference-less VCO Based CDR with Separate Proportional Path Technology in 65nm CMOS

A 1-Gbps reference-less burst-mode CDR with embedded TDC in a 65-nm CMOS process.

A 12.5gbps Dual Loop Quarter Rate Cdr Using Lock Detecting Technique In 55nm Cmos Process