Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A 16-Gb/s Baud-Rate CDR Circuit With One-Tap Speculative DFE and Wide Frequency Capture Range

A 4–20-Gb/s 1.87-pJ/b Continuous-Rate Digital CDR Circuit With Unlimited Frequency Acquisition Capability in 65-nm CMOS

A 12.5-mb/s to 2.7-Gb/s continuous-rate CDR with automatic frequency acquisition and data-rate readback

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A 40 Gb/s 74.9 mW PAM4 receiver with novel clock and data recovery

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 1-Gbps reference-less burst-mode CDR with embedded TDC in a 65-nm CMOS process.

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

A 6‐to‐38Gb/s capture‐range bang‐bang clock and data recovery circuit with deliberate‐current‐mismatch frequency detection and interpolation‐based multiphase clock generation

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A 0.2–7.1-Gb/s Low-Jitter Full-Rate Reference-Less CDR for Communication Signal Analyzers

A 48mw 15-to-28gb/s Source-Synchronous Receiver with Adaptive DFE Using Hybrid Alternate Clock Scheme and Baud-Rate CDR in 65nm CMOS.

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A Fully-Synthesizable 10.06gbps 16.1mw Injection-Locked CDR in 28nm FDSOI.

A 5 Gb/s Low Area CDR for Embedded Clock Serial Links

A Sub-0.25-pJ/bit 47.6-to-58.8-Gb/s Reference-Less FD-Less Single-Loop PAM-4 Bang-Bang CDR With a Deliberate-Current-Mismatch Frequency Acquisition Technique in 28-nm CMOS

A 5/10 Gb/s Dual-Mode NRZ/PAM4 CDR in 65-Nm CMOS

A 781mbps-5gbps Dll-Based Cdr With Starting-Control Circuit