A Fractional- N DTC-based ADPLL using path-select multi-delay line TDC and true fractional division technique

Zirui Jin,Ang Hu,Xiaoyu Shan,Dongsheng Liu,Chengcheng Zhang,Jinsong Cui,Xuecheng Zou

DOI: https://doi.org/10.1016/j.mejo.2024.106102

IF: 1.992

2024-01-26

Microelectronics Journal

Abstract:This paper presents a fractional- N all-digital phase-locked loop (ADPLL). A 4-bit multi-delay line time-to-digital converter (MDL-TDC) using path selection technique is proposed to achieve a 4-ps resolution with 0.24-mW power consumption at 52 MS/s. A TDC offset calibration method is used to eliminate TDC metastability. An isolated constant-slope digital-to-time converter (ICS-DTC) is utilized to cancel the quantization noise (Q-noise) and achieve true-fractional delay. By tuning DTC compensation, spur and Q-noise are suppressed by 14 dB. To speed up the locking process of the ADPLL, a counter-based coarse PLL is integrated to monitor and compensate for large frequency and phase jump while consuming almost zero power. The proposed ADPLL is implemented in a 40-nm standard CMOS process, occupying a silicon area of 0.36 mm 2 . When TDC offset calibration is turned on, the in-band noise is suppressed by 20 dB. The measured results show 0.78-ps rms jitter and −40-dBc in-band fractional spur are achieved, corresponding to a figure of merit (FOM) of −235 dB.

engineering, electrical & electronic,nanoscience & nanotechnology