Abstract:A 61-MHz Pierce oscillator constructed in 0.35-<inline-formula> <tex-math notation="LaTeX">$\mu \text{m}$ </tex-math></inline-formula> CMOS technology and referenced to a polysilicon surface-micromachined capacitive-gap-transduced wine-glass disk resonator has achieved phase noise marks of −119 dBc/Hz at 1-kHz offset and −139 dBc/Hz at far-from-carrier offsets. When divided down to 13 MHz, this corresponds to −132 dBc/Hz at 1-kHz offset from the carrier and −152 dBc/Hz far-from-carrier, sufficient for mobile phone reference oscillator applications, using a single MEMS resonator, i.e., without the need to array multiple resonators. Key to achieving these marks is a Pierce-based circuit design that harnesses a MEMS-enabled input-to-output shunt capacitance more than <inline-formula> <tex-math notation="LaTeX">$100\times $ </tex-math></inline-formula> smaller than exhibited by macroscopic quartz crystals to enable enough negative resistance to instigate and sustain oscillation while consuming only <inline-formula> <tex-math notation="LaTeX">$78~\mu \text{W}$ </tex-math></inline-formula> of power—a reduction of <inline-formula> <tex-math notation="LaTeX">$\sim 4.5\times $ </tex-math></inline-formula> over previous work. Increasing the bias voltage of the resonator by 1.25 V further reduces power consumption to <inline-formula> <tex-math notation="LaTeX">$43~\mu \text{W}$ </tex-math></inline-formula> at the cost of only a few decibels in far-from-carrier phase noise. This oscillator achieves a 1-kHz-offset figure of merit (FOM) of −231 dB, which is now the best among published chip-scale oscillators to date. A complete linear circuit analysis quantifies the influence of resonator input-to-output shunt capacitance on power consumption and predicts further reductions in power consumption via reduction of electrode-to-resonator transducer gaps and bond pad sizes. The demonstrated phase noise and power consumption posted by this tiny MEMS-based oscillator are attractive as potential enablers for low-power “set-and-forget” autonomous sensor networks and embedded radios.

Low-Power MEMS-Based Pierce Oscillator Using a 61-MHz Capacitive-Gap Disk Resonator

Substrate Integrated High-Q Dielectric Resonators for Low Phase Noise Oscillator

A 0.8 V Low Power Low Phase-Noise Pll

A Low Power PLL Circuit with Area-Saving Loop Filter Applied in MEMS

Dielectric Resonators with High $Q$-Factor for Tunable Low Phase Noise Oscillators

A LOW POWER, LOW PHASE NOISE FBAR OSCILLATOR

1.05-GHz CMOS oscillator based on lateral- field-excited piezoelectric AlN contour- mode MEMS resonators

A Low Area, Switched-Resistor Based Fractional-N Synthesizer Applied to a MEMS-Based Programmable Oscillator

A Compact Square-Geometry Quad-Core 19 GHz Class-F VCO with Parallel Inductor-sharing Technique achieving -137.2 dBc/Hz Phase Noise at 10MHz Offset

A Reference-Free Capacitive-Discharging Oscillator Architecture Consuming 44.4 pW/75.6 nW at 2.8 Hz/6.4 kHz

A Sub-µg Bias-Instability MEMS Oscillating Accelerometer with an Ultra-Low-Noise Read-Out Circuit in CMOS

A Low Phase Jitter MEMS Oscillator with Centrally-Anchored Piezoelectric Resonator for Wide Temperature Range Real Time Clock Applications

Low-phase-noise surface acoustic wave oscillator using phononic crystal bandgap-edge mode

A Low Impedance CMOS-MEMS Capacitive Resonator Based on Metal-Insulator-Metal (MIM) Capacitor Structure

Vhf Cmos-Mems Oxide Resonators With Q > 10,000

Ultra-sensitive magnetic field sensor based on a low-noise magnetoelectric MEMS-CMOS oscillator

Chip Scale Atomic Resonator Frequency Stabilization System with Ultra-Low Power Consumption for Optoelectronic Oscillators.

Analysis and Design Considerations for Achieving the Fundamental Limits of Phase Noise in mmWave Oscillators With On-Chip MEMS Resonator

A 76 GHz Oscillator by High-Q Differential Transmission Line Loaded with Split Ring Resonator in 65-Nm CMOS

Miniaturized Multi-Cantilever MEMS Resonators with Low Motional Impedance

A 47μW 204MHz AlN Contour-Mode MEMS based tunable oscillator in 65nm CMOS