Abstract:A 61-MHz Pierce oscillator constructed in 0.35-<inline-formula> <tex-math notation="LaTeX">$\mu \text{m}$ </tex-math></inline-formula> CMOS technology and referenced to a polysilicon surface-micromachined capacitive-gap-transduced wine-glass disk resonator has achieved phase noise marks of −119 dBc/Hz at 1-kHz offset and −139 dBc/Hz at far-from-carrier offsets. When divided down to 13 MHz, this corresponds to −132 dBc/Hz at 1-kHz offset from the carrier and −152 dBc/Hz far-from-carrier, sufficient for mobile phone reference oscillator applications, using a single MEMS resonator, i.e., without the need to array multiple resonators. Key to achieving these marks is a Pierce-based circuit design that harnesses a MEMS-enabled input-to-output shunt capacitance more than <inline-formula> <tex-math notation="LaTeX">$100\times $ </tex-math></inline-formula> smaller than exhibited by macroscopic quartz crystals to enable enough negative resistance to instigate and sustain oscillation while consuming only <inline-formula> <tex-math notation="LaTeX">$78~\mu \text{W}$ </tex-math></inline-formula> of power—a reduction of <inline-formula> <tex-math notation="LaTeX">$\sim 4.5\times $ </tex-math></inline-formula> over previous work. Increasing the bias voltage of the resonator by 1.25 V further reduces power consumption to <inline-formula> <tex-math notation="LaTeX">$43~\mu \text{W}$ </tex-math></inline-formula> at the cost of only a few decibels in far-from-carrier phase noise. This oscillator achieves a 1-kHz-offset figure of merit (FOM) of −231 dB, which is now the best among published chip-scale oscillators to date. A complete linear circuit analysis quantifies the influence of resonator input-to-output shunt capacitance on power consumption and predicts further reductions in power consumption via reduction of electrode-to-resonator transducer gaps and bond pad sizes. The demonstrated phase noise and power consumption posted by this tiny MEMS-based oscillator are attractive as potential enablers for low-power “set-and-forget” autonomous sensor networks and embedded radios.

A 47μW 204MHz AlN Contour-Mode MEMS based tunable oscillator in 65nm CMOS

A 60GHz voltage-controlled oscillator with a 3.6GHz tuning range in 180nm CMOS technology

1.05-GHz CMOS oscillator based on lateral- field-excited piezoelectric AlN contour- mode MEMS resonators

A 40 Nm Cmos V-Band Vco with On-Chip Body Bias Voltage Control Technique

A 300-500 MHz Tunable Oscillator Exploiting Ten Overtones in Single Lithium Niobate Resonator

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

A 47.6–71.0-GHz 65-nm CMOS VCO Based on Magnetically Coupled -Type LC Network

A Low Power 1.0 GHz VCO in 65Nm-Cmos LP-process.

A 20.7–31.8ghz Dual-Mode Voltage Waveform-Shaping Oscillator with 195.8dbc/hz FoMT in 28nm CMOS

A 293-to-303 GHz Fundamental VCO with -4Dbm Peak Output Power in 40nm CMOS

A 2ghz Low Power Differentially Tuned CMOS Monolithic LC-VCO

Design of a 60 GHz, 11.7% Tuning-Range Voltage-Controlled Oscillator in 65 Nm CMOS Technology

A High Power C-Band Algan/Gan Hemt Mmic Vco

A 3.65-4.10 GHz Class-C VCO with 189.1 Dbc/hz FoM Based on Low Electromagnetic Coupling

A Low Phase Jitter MEMS Oscillator with Centrally-Anchored Piezoelectric Resonator for Wide Temperature Range Real Time Clock Applications

Quasi-linear Frequency Tuning for CMOS-MEMS Resonators

An Ultra-Low-Power 65 nm Single-Tank 24.5-to-29.1 GHz Gm-Enhanced CMOS LC VCO Achieving 195.2 dBc/Hz FoM at 1 MHz

A -193.1Dbc/hz FOM 1.08mw Low Power 10ghz VCO in 22nm CMOS Technology

A 2.7-Mw 1.36–1.86-Ghz LC-VCO with a FOM of 202 Dbc/hz Enabled by a 26%-Size-reduced Nano-Particle-Magnetic-Enhanced Inductor

Low-Power MEMS-Based Pierce Oscillator Using a 61-MHz Capacitive-Gap Disk Resonator