Abstract:Piezoelectric vibration energy harvesting has drawn much research interest over the last decade toward the goal of enabling self-sustained wireless sensor nodes. In order to make use of the harvested energy, interface circuits are needed to rectify and manage the energy. Among all active interface circuits, synchronized switch harvesting on inductor (SSHI) and synchronous electric charge extraction are widely employed due to their high energy efficiencies. However, the cold-startup issue still remains, since an interface circuit needs a stable dc supply and the whole system is completely out of charge at the beginning of implementations or after a certain period of time without input vibration excitation. In this paper, a new cold-startup SSHI interface circuit is presented, which dynamically increases the open-circuit voltage generated from the piezoelectric transducer in the cold state to start the system under much lower excitation levels. The proposed circuit is designed and fabricated in a 0.18-mu m CMOS process and experimentally validated together with a custom microelectromechanical system harvester, which is designed with split electrodes to work with the proposed power extraction circuit. The experiments were performed to start the system from the cold state under variable excitation levels. The results show that the proposed system lowers the required excitation level by at least 50% in order to perform a cold startup. This aids restarting of the energy harvesting system under low excitation levels each time it enters the cold state.

30–300mV input, ultra-low power, self-startup DC-DC boost converter for energy harvesting system

Ultra-Low Power Boost Converter with Constant On-Time-Based Mppt for Energy Harvesting Applications

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

A 95.3% Peak Efficiency 38mV overshoot and 5mV/A load regulation Hysteretic Boost Converter with Anti-Phase Emulate Current Control

A Compact Dickson Hybrid Boost Converter with 5-Mv Input 90.5% Peak Efficiency and On-Chip Cold-Start for Thermoelectric Energy Harvesting

A Dickson Hybrid Boost Converter With On-Chip Cold-Start for Thermoelectric Energy Harvesting.

A Low-Voltage Self-Starting Boost Converter Using MPPT with Pulse Multiplication for Energy Harvesting

An Ultra-low-power Gain-boost Class-C Inverter and Its Application

Start-up module for low voltage energy harvesting systems

A high-efficiency full-wave CMOS rectifying charge pump for RF energy harvesting applications

A Variable Step-Down Conversion Ratio Switched Capacitor DC-DC Converter for Energy Harvesting Systems Working in Intermittent Mode

A burst-mode based boost converter harvesting photovoltaic energy for low power applications

A fully integrated 28nm CMOS dual source adaptive thermoelectric and RF energy harvesting circuit with 110mv startup voltage

Ultra-low-voltage Low-Power Charge Pump for Solar Energy Harvesting Systems

An On-Chip Transformer-Based Self-Startup Hybrid SIDITO Converter for Thermoelectric Energy Harvesting

A Single Inductor Tri-Input Dual-Output Buck-Boost DC-DC Converter with MPPT for Multi-Source Energy Harvesting.

A 3.5 mV Input Single-Inductor Self-Starting Boost Converter with Loss-Aware MPPT for Efficient Autonomous Body-Heat Energy Harvesting

An integrated RF energy-harvesting system with broad input voltage range and high power conversion efficiency

A Cold-Startup SSHI Rectifier for Piezoelectric Energy Harvesters with Increased Open-Circuit Voltage

A 10 mV-500 mV Input Range, 91.4% Peak Efficiency Adaptive Multi-Mode Boost Converter for Thermoelectric Energy Harvesting

A 1μW-to-158μW Output Power Pseudo Open-Loop Boost DC-DC with 86.7% Peak Efficiency using Frequency-Programmable Oscillator and Hybrid Zero Current Detection.