Abstract:Energy harvesting from natural environment gives range of benefits for the Internet of things. Scavenging energy from photovoltaic (PV) cells is one of the most practical solutions in terms of power density among existing energy harvesting sources. PV power systems mandate the maximum power point tracking (MPPT) to scavenge the maximum possible solar energy. In general, a switching-mode power converter, an MPPT charger, controls the charging current to the energy storage element (a battery or equivalent), and the energy storage element provides power to the load device. The mismatch between the maximum power point (MPP) current and the load current is managed by the energy storage element. However, such architecture causes significant energy loss (typically over 20%) and a significant weight/volume and a high cost due to the cascaded power converters and the energy storage element. This paper pioneers a converter-less PV power system with the MPPT that directly supplies power to the load without the power converters or the energy storage element. The proposed system uses a nonvolatile microprocessor to enable an extremely fine-grain dynamic power management in a few hundred microseconds. This makes it possible to match the load current with the MPP current. We present detailed modeling, simulation, and optimization of the proposed energy harvesting system including the radio frequency transceiver. Experiments show that the proposed setup achieves an 87.1% of overall system efficiency during a day, 30.6% higher than the conventional MPPT methods in actual measurements, and thus a significantly higher duty cycle under a weak solar irradiance.

A Single Inductor Tri-Input Dual-Output Buck-Boost DC-DC Converter with MPPT for Multi-Source Energy Harvesting.

A Low-Voltage Self-Starting Boost Converter Using MPPT with Pulse Multiplication for Energy Harvesting

A Triple-Mode DC–DC Converter with Wide Input and Load Ranges for Energy Harvesting in IoT Edge Nodes

Ultra-Low Power Boost Converter with Constant On-Time-Based Mppt for Energy Harvesting Applications

Three-Port Power Electronic Interface With Decoupled Voltage Regulation and MPPT in Electromagnetic Energy Harvesting Systems

A SIDIDO DC-DC Converter With Dual-Mode and Programmable-Capacitor-Array MPPT Control for Thermoelectric Energy Harvesting.

A 90% peak efficiency single-inductor dual-output buck-boost converter with extended-PWM control

A Dickson Hybrid Boost Converter With On-Chip Cold-Start for Thermoelectric Energy Harvesting.

30–300mV input, ultra-low power, self-startup DC-DC boost converter for energy harvesting system

The MPPT Application of the FSBB Converter with MHz ZVS Digital Control

Storage-Less and Converter-Less Photovoltaic Energy Harvesting with Maximum Power Point Tracking for Internet of Things

A Compact Dickson Hybrid Boost Converter with 5-Mv Input 90.5% Peak Efficiency and On-Chip Cold-Start for Thermoelectric Energy Harvesting

27.1 An 84% Peak Efficiency Bipolar-Input Boost/Flyback Hybrid Converter With MPPT and on-Chip Cold Starter for Thermoelectric Energy Harvesting

A Bipolar-Input Bipolar-Output Dc-Dc Converter For Thermoelectric Energy Harvesting

A 3.5 mV Input Single-Inductor Self-Starting Boost Converter with Loss-Aware MPPT for Efficient Autonomous Body-Heat Energy Harvesting

A High Efficiency Single-Inductor Dual-Output Buck Converter With Adaptive Freewheel Current And Hybrid Mode Control

DTMOS-Based Pulse Transformer Boost Converter With Complementary Charge Pump for Multisource Energy Harvesting

An On-Chip Transformer-Based Self-Startup Hybrid SIDITO Converter for Thermoelectric Energy Harvesting

Self-powered multi-PZTs energy harvesting interface based on extensible PSSHI rectification with power region optimization technique

A TEG Efficiency Booster with Buck–Boost Conversion

A Three-Port DC-DC Converter with Partial Power Regulation for a Photovoltaic Generator Integrated with Energy Storage