Abstract:Recent advances in energy-harvesting techniques have allowed wearable and IoT devices to operate without batteries. A thermoelectric generator (TEG) is one energy source that can provide a bipolar voltage that is proportional to the temperature difference between its two sides. Most of the prior TEG-harvesting systems could handle the positive input voltage [1–3]; however, the TEG’s input voltage polarity may reverse due to environmental changes. Only a few prior publications provide a method to deal with the bipolar input voltage [4–6]. To harvest bipolar input energy, a switch-matrix-based boost converter is proposed in [4], but it cannot self-start and dynamically track the maximum power point. [5] and [6] provide methods for bipolar self-startup with an ultra-low input voltage, but both of them suffer from a low conversion efficiency. Hence, there is no complete system suitable for bipolar-input TEG energy harvesting. A solution must address three challenges: (1) the transfer of energy from a bipolar input voltage via a high-efficiency converter; (2) system self-start-up with a reasonably low bipolar input voltage; (3) a maximum power point tracking (MPPT) method for bipolar input voltage. This paper proposes a bipolar-input boost/flyback hybrid converter (BFHC) with an on-chip cold start-up for TEG energy harvesters.

A fully integrated 28nm CMOS dual source adaptive thermoelectric and RF energy harvesting circuit with 110mv startup voltage

A Dickson Hybrid Boost Converter With On-Chip Cold-Start for Thermoelectric Energy Harvesting.

A Compact Dickson Hybrid Boost Converter with 5-Mv Input 90.5% Peak Efficiency and On-Chip Cold-Start for Thermoelectric Energy Harvesting

A high-efficiency full-wave CMOS rectifying charge pump for RF energy harvesting applications

A Bipolar-Input Thermoelectric Energy-Harvesting Interface with Boost/Flyback Hybrid Converter and On-Chip Cold Starter

An On-Chip Transformer-Based Self-Startup Hybrid SIDITO Converter for Thermoelectric Energy Harvesting

A High-Efficiency Dual-Polarity Thermoelectric Energy-Harvesting Interface Circuit With Cold Startup and Fast-Searching ZCD

An integrated RF energy-harvesting system with broad input voltage range and high power conversion efficiency

Co-design of an Auxiliary Self-Bias Module and a CMOS Rectifier for RF Energy Harvesting

30–300mV input, ultra-low power, self-startup DC-DC boost converter for energy harvesting system

RF Energy Harvesting with Wide Input Power Range

A 10 mV-500 mV Input Range, 91.4% Peak Efficiency Adaptive Multi-Mode Boost Converter for Thermoelectric Energy Harvesting

A 3.5 mV Input Single-Inductor Self-Starting Boost Converter with Loss-Aware MPPT for Efficient Autonomous Body-Heat Energy Harvesting

A 1.8V Output RF Energy Harvester at Input Available Power of −20 dBm

A Fully-Integrated CMOS Dual-Band RF Energy Harvesting Front-End Employing Adaptive Frequency Selection

A Self-Bias Rectifier with 27.6% PCE at -30Dbm for RF Energy Harvesting

Low Voltage and Low Power Self-Startup Oscillator-Driven Boost Converter for Thermoelectric Generator Operating at Low Temperature

27.1 An 84% Peak Efficiency Bipolar-Input Boost/Flyback Hybrid Converter With MPPT and on-Chip Cold Starter for Thermoelectric Energy Harvesting

Design of High-efficiency Micro-watt RF Energy Harvesting System

A hybrid threshold self-compensation rectifier for RF energy harvesting

An efficient boost converter control for thermoelectric energy harvesting