Abstract:Piezoelectric vibration energy harvesting has drawn much research interest over the last decade toward the goal of enabling self-sustained wireless sensor nodes. In order to make use of the harvested energy, interface circuits are needed to rectify and manage the energy. Among all active interface circuits, synchronized switch harvesting on inductor (SSHI) and synchronous electric charge extraction are widely employed due to their high energy efficiencies. However, the cold-startup issue still remains, since an interface circuit needs a stable dc supply and the whole system is completely out of charge at the beginning of implementations or after a certain period of time without input vibration excitation. In this paper, a new cold-startup SSHI interface circuit is presented, which dynamically increases the open-circuit voltage generated from the piezoelectric transducer in the cold state to start the system under much lower excitation levels. The proposed circuit is designed and fabricated in a 0.18-mu m CMOS process and experimentally validated together with a custom microelectromechanical system harvester, which is designed with split electrodes to work with the proposed power extraction circuit. The experiments were performed to start the system from the cold state under variable excitation levels. The results show that the proposed system lowers the required excitation level by at least 50% in order to perform a cold startup. This aids restarting of the energy harvesting system under low excitation levels each time it enters the cold state.

A New Transformer-Based Startup Scheme with Novel Voltage Monitors for Energy Harvesting

A 95.3% Peak Efficiency 38mV overshoot and 5mV/A load regulation Hysteretic Boost Converter with Anti-Phase Emulate Current Control

A 20-300mV transformer-based self-startup flyback converter with MPPT and ZCS control for thermoelectric energy harvesting

Start-up module for low voltage energy harvesting systems

A novel start-up scheme for modular multilevel converter

A 100mv Input Voltage, Multi-step Self-Startup Boost Converter Achieving 50X Voltage Step-up with Standard 0.18 Μm CMOS Process for Energy Harvesting Application

An On-Chip Transformer-Based Self-Startup Hybrid SIDITO Converter for Thermoelectric Energy Harvesting

A Compact Dickson Hybrid Boost Converter with 5-Mv Input 90.5% Peak Efficiency and On-Chip Cold-Start for Thermoelectric Energy Harvesting

30–300mV input, ultra-low power, self-startup DC-DC boost converter for energy harvesting system

A Two-Step Self-Startup Hybrid Structure Step-Up Converter Using Standard 5P0 MOSFETs Achieving 36 × Voltage Boosting with 50 Mv Input Voltage and 84 × Input Voltage Range for Self-Powered IoT Applications

A Dickson Hybrid Boost Converter With On-Chip Cold-Start for Thermoelectric Energy Harvesting.

A Cold-Startup SSHI Rectifier for Piezoelectric Energy Harvesters with Increased Open-Circuit Voltage

A Simple Open-loop Soft Startup Method Based on Operation Mode Analysis for LCC Converters Used in High-voltage DC Power Supply

Safe Startup Method for Zero-Voltage-Switching MOSFET Grid Inverter

Startup Strategy with Constant Peak Transformer Current for Hybrid Multilevel Energy Router

A Batteryless Single-Inductor Boost Converter with 190 Mv Self-Startup Voltage for Thermal Energy Harvesting over a Wide Temperature Range.

A Startup Scheme for Zero-Voltage-switching PV Inverter

Ultra-Low Power Boost Converter with Constant On-Time-Based Mppt for Energy Harvesting Applications

A Review of Start-Up Circuits for Low Voltage Self-Powered DC-Type Energy Harvesters

A Novel Ladder Control Assisted Startup for Primary Side Regulated Flyback Converter

A fully integrated 28nm CMOS dual source adaptive thermoelectric and RF energy harvesting circuit with 110mv startup voltage