Abstract:The surface reconstruction of the Fe catalyst films due to high temperature processing in hydrogen prior to nanotube nucleation and its effect on the growth morphologies of partially filled carbon nanotubes (CNTs) synthesized using atmospheric pressure chemical vapor deposition (APCVD) of propane was investigated. Results show that pre-heating of the catalyst film deeply influences the particle size distribution, which governs the growth morphologies of the corresponding CNTs. The distribution of the catalyst particles over the Si substrate was analyzed before and after the heat treatment by atomic force microscopy (AFM) which reveals that heat treatment causes clusters of catalyst to coalesce and form macroscopic islands. The X-ray diffraction (XRD) pattern of the grown material indicates that they are graphitic in nature. Scanning electron microscopy (SEM) analysis suggested that the growth density strongly depends on the pre heat treatment of the Fe catalyst film. Multiwalled CNTs with partial catalyst filling were observed via high-resolution transmission electron microscopy (HRTEM) measurements. The degree of graphitization of the CNTs also depends on the pre heating as demonstrated by Raman analysis. A simple model for the growth of partially catalyst filled nanotubes is proposed.

Effect of catalyst on the growth of aligned carbon prepared by microwave chemical vapor deposition

Effects of Temperature and Catalyst Concentration on the Growth of Aligned Carbon Nanotubes

Influence of Microstructures of Fe Catalyst Film on Growth of Aligned Carbon Nanotubes

Preferential Growth of Carbon Nanotubes/Nanofibers Using Lithographically Patterned Catalysts

Effect of surface morphology of Ni thin film on the growth of aligned carbon nanotubes by microwave plasma-enhanced chemical vapor deposition

Effect of Catalyst on Morphology of Carbon Nano-Materials Prepared in A Nano-Agglomerate Bed

Catalysts effect on morphology of carbon nanotubes prepared by catalytic chemical vapor deposition in a nano-agglomerate bed

Influence of Cerium Metal As Catalyst on the Growth and Structure of Single-Walled Carbon Nanotubes

Synthesis of Aligned Carbon Nanotubes by Thermal Chemical Vapor Deposition

J2240204 Evaluation of the Properties and Alignment of Carbon Nanotube Sheet Grown by CVD Method

Microstructure Control of Fe Catalyst Films for the Growth of Multiwalled Carbon Nanotube Arrays

Synthesis and Magnetic Properties of Aligned Carbon Nanotubes by Microwave-Assisted Pyrolysis of Acetylene

Controlled Growth of Fe Catalyst Film for Synthesis of Vertically Aligned Carbon Nanotubes by Glancing Angle Deposition

The effect of Fe and Ni catalysts on the growth of multiwalled carbon nanotubes using chemical vapor deposition

Effects of the Restructuring of Fe Catalyst Films on Chemical Vapor Deposition of Carbon Nanotubes

Effect of adding nickel to iron–alumina catalysts on the morphology of as-grown carbon nanotubes

Pre-heating effect on the catalytic growth of partially filled carbon nanotubes by chemical vapor deposition

Multi-Directional Growth of Aligned Carbon Nanotubes Over Catalyst Film Prepared by Atomic Layer Deposition

How Catalysts Affect the Growth of Single-Walled Carbon Nanotubes on Substrates

THE GROWTH OF ALIGNED CARBON NANOTUBES ON FeNiCo CATALYST FILMS

Carbon Nanotube Synthesis and Parametric Study Using CaCO3 Nanocrystals As Catalyst Support by CVD