Abstract:Although ammonia-based CO2 capture has attracted global research attention, several inherent issues with this technology remain to-be resolved. To address these problems, a new design for carbon capture using ammonia is proposed on the basis of anti-solvent crystallization, also known as precipitation crystallization. The crystallization of a low carbonized absorbent was found to-be, enhanced in the crystallizer using an-anti-solvent process, which can maintain a high absorption rate and simultaneously prevent crystallization from occurring in the absorption tower. Energy consumption for sorbent regeneration is, reduced by regenerating the crystal product rather than the rich-solution. Energy-cascade utilization-is an effective way to improve the use of energy. In this work, steam was used to drive a heat pump that extracts energy from discharged flue gas from a wet flue gas desulfurization system in. a power plant to enablethe recovery of low-temperature residual energy; this energy can be used in the crystal regeneration process, thereby further reducing the energy required for regeneration. Aspen Plus (version 8.4) software was adopted:to simulate the flue gas condensation, heat-pump circulation, and steam drive'-subsystems. The simulation results showed that 10 heat pumps (6.04 MW) can meet the regeneration energy requirement of the CO, capture process in a 300 MW coal-fired unit and recycle 40.6 MW of low-temperature heat. The extraction steam requirement is low, which reduces the impact on power-generation.

Rate-Based Modeling Of Regeneration Process For Co2 Capture By Aqueous Ammonia Solution In A Pilot Plant At Munmorah Power Station

Rate-based modelling of CO2 regeneration in ammonia based CO2 capture process

Rate-Based Modeling of CO2 Absorption in Aqueous NH3 in a Packed Column

Rate based modeling of absorption and regeneration for CO2 capture by aqueous ammonia solution

A Comprehensive Model for Regeneration Process of CO 2 Capture Using Aqueous Ammonia Solution

Rate-based modelling of combined SO 2 removal and NH 3 recycling integrated with an aqueous NH 3 -based CO 2 capture process

Process modeling of an advanced NH₃ abatement and recycling technology in the ammonia-based CO₂ capture process

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Modeling Analysis of Energy Requirement in Aqueous Ammonia Based CO2 Capture Process

Results from trialling aqueous ammonia-based post-combustion capture in a pilot plant at Munmorah Power Station: Gas purity and solid precipitation in the stripper

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

Reaction Sensitivity Analysis of Regeneration Process of CO2 Capture Using Aqueous Ammonia

Experimental Studies And Rate-Based Process Simulations Of Co2 Absorption With Aqueous Ammonia Solutions

Systematic study of aqueous monoethanolamine‐based CO2 capture process: model development and process improvement

Modelling analysis of solid precipitation in an ammonia-based CO 2 capture process

Analysis on Regeneration Energy of NH3-based CO2 Capture with Equilibrium-based Simulation Method

Experimental And Rate-Based Modeling Study Of Co2 Capture By Aqueous Monoethanolamine

Modeling and Economic Analysis on Combined Capture of CO2 and SO2 in Flue Gas Using Aqueous Ammonia

Aqueous Ammonia Based Post Combustion Capture: Results from Pilot Plant Operation, Challenges and Further Opportunities

Comparison of Thermodynamic Models for Carbon Capture with Aqueous Ammonia

Simulation Optimization of A New Ammonia-Based Carbon Capture Process Coupled with Low-Temperature Waste Heat Utilization